If there is no suction device, drain the oil through the drain hole of the oil pan.
2. After draining the oil, tighten the drain plug to 30 Nm (thread M14).
3. Fill with oil (9 l) through the filler neck (2).
Note: To avoid exceeding the engine oil level when filling, fill the portion of oil 0.5-1 liter less than the specified amount. When checking the oil level, you can top it up.
Caution: Do not exceed the engine oil level. If this happens, the excess oil should be removed.
Examination
4. Start the engine.
Caution: When starting the engine for the first time, do not increase its speed until the low oil pressure warning light goes out,
5. After warming up the engine, make sure there are no oil leaks through the drain plug.
6. Check the oil level. This should be done 2 minutes after stopping a fully warmed up engine on a level surface.
If there is a fluid leak, the cause must be identified and eliminated.
