Car steering Mercedes Sprinter I (903)

Steering — General Information
All models are equipped with rack and pinion steering and hydraulic booster. The steering is located between the engine and the front shield, equipped with progressive...

Power steering fluid reservoir
Figure 257. Location of the power steering fluid reservoir The power steering system uses a spool valve that operates in a cylinder. Depending on the direction of...

Removal the steering gear
When carrying out any work with the power steering, the following rules must be followed: when carrying out all work, maintain maximum cleanliness; before loosening any...

Replacing tie rod ends and protective covers
To replace the tip, place the vehicle on supports and remove the wheel. To replace the cuff, the tip with the hinge must be removed. Figure 258. Connection of the...

Checking the steering play
Below is a description of the actions to take during periodic steering checks. Based on the results of the checks, you can draw a conclusion about how to fix the...

Checking the play in the steering rod joints
Figure 262. Steering rod: 1 — steering rod joint; 2 - protective cover With the wheel screwed on from underneath the car, grab the hinge 1 (figure 262) steering rod and...

Checking the steering gear protective covers
Figure 262. Steering rod: 1 — steering rod joint; 2 - protective cover Shown in the picture 262 Protective cover 2 should be checked along its entire length for cracks...

Filling the power steering system with fluid
After repairing the steering mechanism, the hydraulic power steering system should be filled with the fluid required by Mercedes-Benz and then the hydraulic drive system...

Bleeding the power steering system
Bleeding of the power steering system must be carried out in the following order: if the fluid level in the system stops decreasing after a short engine start, leave the...

Checking the tightness of the power steering system
Since fluid may occasionally leak from the system, a quick check will help determine the cause of the leak. The tightness test of the system must be carried out with an...

Power steering pump drive V-belt, belt replacement
The power steering pump, like other units in front of the engine, is driven by a V-belt drive. For a description of belt removal and installation, see. sec. " Cooling...

Removal and installation the power steering pump
Figure 264. Location of the power steering pump and its reservoir on a diesel engine without turbocharging: 1 - flexible high pressure hose; 2 - return hose; 3 - pulley...

Front wheel alignment angles
Adjustment of the front wheel alignment angles is carried out using optical instruments. Therefore, it is recommended to contact a service station if there is a...

Possible steering malfunctions and how to fix them
1. The steering wheel is hard to turn a. Uneven tire pressure. Bring it up to standard b. Insufficient fluid level in the power steering reservoir. Add liquid c. Jamming...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More similar sections for repairing other models

☛ Chassis: Steering car Mercedes W168 (1997-2004)
☛ Chassis: Steering car Mercedes W203 (2000-2007)
☛ Chassis: Steering car Mercedes W124 (1984-1995)
☛ Chassis: Steering car Mercedes W463 (1999-2019)
☛ Chassis: Steering car Mercedes W163 (1997-2005)
☛ Chassis: Steering car Mercedes W220 (1998-2005)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

Vito 1 (1996-2003)