Car steering Mercedes S-Class (W220)

Car Wheel Alignment Angles — General Information
Wheel alignment angles have a significant impact on vehicle stability, tire wear and fuel consumption. The angle values are given in the Specifications. Camber is the...

Conditions for checking wheel alignment angles
Checking the vehicle's installation angles requires an inspection pit or a special measuring lift. When taking measurements, the following conditions must be met: The...

Front wheel alignment
Checking and adjusting the front wheel alignment 4MATIC models Rear wheel drive models Arrows - Centering the steering wheel position; 055 - Retaining device; 055b -...

Rear wheel adjustment
Rear wheel alignment adjustment Model shown with AIRMATIC Eccentric rubber bushing 60 - Steering rod; 60a - Bolt; 60b - Rubber bushing; +X = +1.5 mm; –X = –1.5 mm; 60c -...

Checking the vehicle body clearance
Measuring suspension clearance. (Corresponds to the angle of inclination of the drive shaft to the horizontal) 1. The level of the front axle of the vehicle is checked...

Removal and installation the steering gear
1g - Clamping bar; 10a - Drawbar Hinge; 21 - Rubber bushing; 23 - Rack and pinion steering; 23a - Screws; 23g - Bolts, 45 Nm + 60°; 23k - Screen; 23s - Oil line pressure...

Power Steering Pump — Removal and Installation
Removal 1. Remove the fluid from the power steering reservoir. 2. Disconnect the intake pipe from the tank. 3. Remove the feed pipe, fan shroud, distributor cap, etc. to...

Disassembling and assembling the power steering pump
Power steering pump (disassembled) 2 - Pump body; 3 - Plate; 4 - Flange; 6 - Cam insert; 7 - Rotor; 11 - Drive shaft; 13 - Seal; 16 - Blade; 18, 34a, 34b - Retaining...

Disassembly and assembly of the electronically adjustable steering column
Disassembly and assembly of the electronically adjustable steering column Steering column adjustment elements 60 - Height adjustment electric motor with gearbox; 60e -...

Removal and installation the lower steering shaft
Removal Unscrew nut 96. Installation 1. Tighten nut 96 on the upper steering shaft 70g. Install the lower steering shaft on nut 96 and tighten them together, continuing...

Removal and installation the drive for telescopic adjustment of the steering column
Removal 1. Unscrew bolt 84 and remove telescopic drive M20m1. 2. Remove locking device 84b and remove pin 84a from outer pipe 81a. 3. Remove the telescopic adjustment...

Removal and installation the pipe stop
Removal Remove retaining ring 83b, disc spring and stop from pipe 81a. Pipe 81a is secured by disc spring and stop. Installation Lubricate the stop 83 and the disc...

Disassembly and assembly of the inner tube
Disassembly 1. Unscrew nut 92d and remove locking plate 92e. Remove disc spring 70e and thrust ring 70d. 2. Remove the steering shaft 70g, thrust ring 70b and retaining...

Installing the top pipe mounting bracket
Fix the bracket 85 at an angle of 90° to the pipe as shown in the illustrations. Adjust the distance "b" between the bracket 85 and the locking ring 70h. The distance...

Removal and installation the locking cylinder
Removal 1. Unscrew the 36a instrument panel shield using the 020 key (models without immobilizer). 2. Remove the L11 coil from the locking cylinder (models with...

Contact spring — removal, inspection and installation
Removal 1. Remove the steering wheel. 2. Remove the lower instrument panel cover. 3. Disconnect the wiring connector from the airbag signal or contact spring A45x1. 4....

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More similar sections for repairing other models

☛ Chassis: Steering car Mercedes W168 (1997-2004)
☛ Chassis: Steering car Mercedes W202 (1993-2000)
☛ Chassis: Steering car Mercedes W210 (1996-2002)
☛ Chassis: Steering car Mercedes W463 (1999-2019)
☛ Chassis: Steering car Mercedes W163 (1997-2005)
☛ Chassis: Steering car Mercedes Vito 2 (2003-2014, diesel)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

W140 (1991-1998)