Clutch and cardan shaft of the car Mercedes S-Class (W126)

Description of the clutch design
The clutch consists of a driving disc, a driven disc and a hydraulic drive. The clutch master disk is fixed to the flywheel, which in turn is fixed to the engine...

Removal, checking and installation the clutch
To remove, you must perform the following operations: Remove the gearbox. Gradually loosen the drive pin mounting bolts by 1-1.5 turns each time until it is relieved....

Bleeding the hydraulic clutch drive
Bleeding the hydraulic clutch drive should be done if the pressed clutch pedal does not return or returns slowly to its original position, gears are difficult to engage,...

Removal air using a special installation
At service stations, air is removed from the hydraulic clutch drive, as a rule, using a special installation. The installation applies pressure to the brake fluid....

Removal and installation the release bearing
If the release bearing is defective, noises are heard when the clutch pedal is pressed. To remove it, you need to: Remove the gearbox. Remove the release bearing (1)...

Clutch Master Cylinder — Removal and Installation
Removal Remove the carpet and floor covering, as well as the cover under the dashboard. Pump out the brake fluid through the air bleed nipple of the working cylinder by...

Checking the thickness of the driven disk
The clutch is self-adjusting and does not require maintenance. The wear of the driven disk is determined by the free travel of the clutch pedal. The thickness of the...

Diagnosing Clutch Faults
Diagnosing Clutch Faults

Removal and installation the propeller shaft
When removing, care must be taken to ensure that the propeller shaft is accurately balanced during manufacture and that it is handled with care. If the propeller shaft...

Removal and installation the intermediate bearing of the propeller shaft
Mark the individual parts of the shaft. First separate the front and then the rear propeller shaft. Remove the safety ring from the groove. Remove the front protective...

Propeller shaft specifications
Propeller shaft specifications Cardan shaft With a normal base two-piece cardan shaft Cardan shaft diameter:# ahead 60.0 mm (cars with automatic transmission) behind...

Tightening torques for threaded connections
Cardan shaft Engine 280S and 280SE 380SE and 500SE 350SE and 450SE Self-locking nuts on the hinge disc 40-50 60-70 60-70 Hexagonal bolts for fastening the intermediate...

Cardan shaft parts
1 - central bushing; 2 - Front disc of the cardan joint; 3 - bolt 45 mm; 4 - front part of the shaft; 5 - clamping nut; 6 - rubber cuff; 7 - bearing; 8 - bolt 25 mm; 9 -...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More similar sections for repairing other models

☛ Transmission: Clutch car Mercedes W168 (1997-2004)
☛ Transmission: Clutch car Mercedes 190 (W201) (1982-1993)
☛ Transmission: Clutch car Mercedes W123 (1976-1985)
☛ Transmission: Clutch car Mercedes W163 (1997-2005)
☛ Transmission: Clutch car Mercedes Vito 1 (1996-2003)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

W140 (1991-1998)