Suspension and steering specifications Note. Separate characteristics are also given in the text of the Chapter and, if they are mandatory, are highlighted in bold. Common parameters Wheel base, mm Standard...
Safety Precautions When Repairing Suspension and Steering When repairing or servicing suspension and steering components, you may encounter the problem of loosening rusted bolts and nuts. These bolts and nuts, located under the...
Vehicle wheel alignment angles, ground clearance General information Wheel alignment has a significant effect on vehicle stability, tire wear and fuel consumption. Angles are given in Specifications . Camber is the...
Removal and installation of the steering mechanism General information The design and principle of operation of a speed-sensitive hydraulic power steering mechanism are shown in Ref. illustrations. Steering gear design 1...
Removal and installation of the lower steering shaft Removing 1. On version 1 steering, unhook the lug (arrow) from blocking plate (96a), unscrew the nut (96) 2. On the steering control version 2, unscrew the nut (96)....
Removal and installation of an emphasis of a pipe Removing Remove retaining ring (83b), disc spring and stop with pipe (81a) Installation Lubricate the stop (83) and disc spring (83a) multipurpose grease and insert into...
Disassembly and assembly of the inner tube Disassembly 1. Loosen the nut (92d) and remove the lock plate (92e), remove the disc spring (70e) and thrust ring (70d). 2. Remove the steering shaft (70g), thrust ring...
Installing the Top Pipe Bracket Models up to ID number 123446 1. Fix the bracket (85), as shown in the illustration (73a), and install it with two holes at an angle of 90°to the installation position...
Removal and installation of the blocking cylinder Models up to 31.08.95 of release Removing Removal and installation of the blocking cylinder (models 140 until 08/31/95, issue.) 1. Remove the steering lock, remove the...
Contact spring — removal, inspection and installation Removal and installation of a contact spring Removing 1. Remove the steering wheel. 2. Remove the bottom cover of the panel of devices. 3. Disconnect the wiring...
Removal and installation of average steering draft Removing 1. Disconnect damper (46) from the middle tie rod (11). 2. While holding the axle bolt, loosen the middle link mounting nuts to the steering arm and swing arm....
Removal and installation of transverse steering draft Removing 1. While holding the shank of the hinge from turning, give the nuts securing the tie rod (10) to the corresponding steering components. 2. With mandrel (051)...