Contents: Disassembly ↡ Assembly ↡
Disassembly
1. Loosen the nut (92d) and remove the locking plate (92e), remove the disc spring (70e) and thrust ring (70d).
2. Remove the steering shaft (70g), thrust ring (70b) and snap ring (70c). Two locking rings are installed on models with a contact spiral. Press the ball bearing out of the tube using the steering shaft and replace it.
Assembly
1. Press the ball bearing (70a) into the outer tube (81b) until it stops. Insert the steering shaft (70g). Press in the second ball bearing (70a).
2. Install the thrust ring (70b) and the snap ring (70c) together onto the steering shaft (70g), make sure that the snap ring (70c) is locked in the correct position in the groove of the steering shaft.
3. Install the thrust ring (70d), disc spring (70e) and new lock plate (92e) with the mounting ears facing the nut, tighten the nut (92d) finger tight.
4. Check the ease of rotation of the steering shaft. The steering shaft should not have axial runout in the tube and should rotate without jamming.