General description of automatic transmission Note. Separate characteristics are also given in the text of the Chapter and, if they are mandatory, are highlighted in bold. Type 5-speed, with electronically...
Electronic control unit tasks and control signals Input and output signals of the control unit AT 722.6 and CAN data bus N15/3 - ETC control unit; Х11/4 - DLC connector; Y3/6b1 - ATF temperature sensor; Y3/6n2 - Speed...
Troubleshooting — general information If a malfunction of the automatic transmission is detected, first of all check the level of the working fluid (refer to section Checking the automatic transmission oil...
Removal and installation of AT with torque converter Automatic transmission 4 - Drain plug of the pallet; 9 - Drain plug of the torque converter; 26 - Wiring connector; 33 - Gearshift lever; 46 - Ground bus; 49 - Oil...
Electrohydraulic control unit AT (AT installed) Electrohydraulic control unit AT 2 - Gearbox; 3 - Pallet; 3a - Connector; 3b, 19a - Bolts; 4 - Drain plug; 5 - Oil filter; 19 - Electro-hydraulic control unit; 21 -...
Dismantling and assembly of a plate of a gear change A - Working pressure control valve. Grease pressure control valve. Valve for adjusting the overlap when turning on 2-3 gears B - Block of inclusion of 1-2 / 4-5 gears....
Disassembly and assembly of the oil pump Disassembly 1. Remove pump gears 22 and 23 from the pump housing. 2. Check radial seal 24 and replace if necessary. 3. Replace O-ring 25. 4. Lubricate the pump gears and...
Disassembly and assembly of the multi-disc brake B1 6b - Outer brake support B1; 6s - Piston; 6d - Piston return disc spring; 6f - Disc spring of the disc block; 6g - Block of gears; 6e, 6h - Retaining rings; 073 -...
Disassembly and assembly of the B2 multi-disc brake 14a - External brake support B2 or piston B3; 14b-d - O-rings for brake B3; 27 - Brake piston B2; 28 - Piston guide ring; 28a-b - O-rings on the piston guide ring; 29,...