Automatic car gearbox Mercedes G-Class (W463)

General information about automatic transmission
When starting off, the automatic transmission (AT) acts as a regular clutch, and during movement it performs the work of shifting gears. All models considered in this...

Automatic Transmission Specifications
General information Type 5-speed, automatic with electronic gear shift control Designation Models 463.250 (G320) 722.610 Models 463.246/249 (G55 AMG and G500) 722.630...

Troubleshooting — General Information
If you detect a fault with your automatic transmission, first check the ATF level (see Chapter Routine care and maintenance ). If the level is insufficient, check the...

General principles of operation of the transmission control system, control signals
General information Design of the electro-hydraulic shift control unit 2a - Hydraulic block; 11 - 13-pin connector; Y3/6 - Electric Shift Control Unit; Y3/6b1 - ATF...

Adjusting the AT shift drive
AT shift drive design 33 - Executive lever; 63 - Shift rod; 97 - Intermediate lever; 98 - Tie rod head; 99 - Bolt; N15/5 - Electronic selector module 1. Drive the car...

Removal and installation the electro-hydraulic shift control unit
Installation details of the electrohydraulic control unit for shifting AT 722.6 2 - Transmission housing; 3 - Oil pan; 3a - Retainer; 3b - Bolt (TORX); 4 - Drain plug of...

Removal and installation of AT with a torque converter
AT installation details 1 - Carter AT; 2 - Filler tube; 3 - Oil pipelines; 4 - Ground busbar; 5 - Cardan shaft; 6 - Rear support of the power unit suspension; 7 - Shift...

Removal and installation the selector module (ESM)
Electronic Selector Module (ESM) Installation Details 1 - Ignition interlock drive cable; 1b - Locking tongue; 1c - Connector; 2 - Bolt; 3 - Intermediate lever; 4 -...

Removal and installation the AT output speed sensor
AT Output Speed Sensor Installation Details (1 of 2) 1 - Hood lock latch release lever; 2 - Lid; 3 - Connector; 4 - AT output speed sensor (B49); 5 - Bolt; 6 - Cable...

Removal and installation the ATF cooler
ATF Cooler Installation Parts (except models 463.246) 1 - Union nut of the nipple connector; 2 - Hollow bolt of the nipple connection; 3 - ATF cooler mounting nuts; 4 -...

ATF Cooler and Oil Lines Flushing
ATF Cooler Flush Kit 1 - Connecting nipple; 2 - Pump; 3 - Reservoir; 4 - Connecting pipes; A - Direction of connection when pumping out ATF; B - Direction of connection...

Removal and installation the electronic transmission control module (TCM/ETC)
TCM Installation Details 1 - Nuts; 2 - Electrical wiring connectors; N15/3 - TCM/ETC 1. On models with the corresponding configuration (code ET2), activate the service...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More similar sections for repairing other models

☛ Transmission: Automatic gearbox car Mercedes W203 (2000-2007)
☛ Transmission: Automatic gearbox car Mercedes W123 (1976-1985)
☛ Transmission: Automatic gearbox car Mercedes W163 (1997-2005)
☛ Transmission: Automatic gearbox 722.6 car Mercedes W140 (1991-1998)
☛ Transmission: Automatic gearbox car Mercedes Sprinter (1995-2000, diesel)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

W463 (1999-2019)