TCM Installation Details
1 - Nuts; 2 - Wiring connectors; N15/3 - TCM/ETC
1. On models of the corresponding configuration (code ET2) activate the service mode of the TELE AID emergency call system (see Section Activation / deactivation of the service mode of the TELE AID emergency call system).
2. Turn off the ignition and remove the key.
3. Connect a booster battery to the original battery, then disconnect the negative cable.
4. Remove the center console (see chapter Body).
5. Disconnect the wiring (2). Give nuts (1), remove TCM (N15/3) from the mounting bolts, then feed it forward towards the passenger footwell.
6. Installation is carried out in the reverse order - when replacing the module, copy information from the old TCM into it (use the STAR DIAGNOSIS scanner).
7. In conclusion, do not forget to deactivate the service mode of the TELE AID system and clear the memory of the processor of the on-board self-diagnosis system (see chapter Engine Electrical Systems).