Car engine repair Mercedes G-Class (W463)

Engine specifications
Note: The parameters used when performing the procedures described in this Chapter are listed below. Detailed standard information can be obtained from authorized...

Checking compression pressure, assessing the condition of the cylinders
Checking the compression pressure Note: An assistant will be required to perform the compression pressure test procedure. Measuring the compression pressure allows you...

Checking the engine with a vacuum gauge
Using a vacuum gauge, you can get information about the condition of the engine and determine if the cylinder head gasket is blown, the fuel system is damaged, the rings...

Replacement of the auxiliary drive belt and elements of its tensioning mechanism
Belt Petrol models (M112/113) Installation details of the auxiliary drive belt on gasoline models (M112/113) 1. Remove the fan assembly (1 and 2) (see Chapter Cooling,...

Checking engine oil pressure
Petrol models Checking Engine Oil Pressure on Petrol Models 1. Remove the engine trim panels/air cleaner assembly by pulling straight up. 2. Remove the cooling system...

Calculating oil consumption
Petrol models produced up to 30.11.00. Measuring oil consumption on petrol models produced up to 11/30/00 087 — HHT 094 - Multiplex cable X11/4 — Diagnostic connector...

Checking and adjusting the basic position of the camshafts
Petrol models Examination Setting the basic position of the camshafts of gasoline engines M112/113 Installation details of cylinder head covers on M112/113 petrol...

Checking the basic position of the balance shaft (M112 and 628 engines only)
M112 Checking the basic position of the balancing shaft of the M112 engine 1 - Grooves in camshafts; 2 - Right camshaft locking plate; 3 - Hole in the rear...

Checking the condition of the timing chain on the M628 engine
Evaluation of the degree of stretching of the timing chain of the M628 engine 1. The degree of stretching of the timing chain can be determined indirectly by the...

Checking the correct setting of the ignition timing on gasoline models
Checking the ignition timing on petrol models 1. The corresponding illustrative material is presented in the illustration Setting the basic position of the camshafts of...

Removal and installation of the power unit
Note: The engine is removed together with the transmission. Disconnecting the electrical wiring Petrol models Schematic diagram of the location of the main components of...

Removal and installation the powertrain suspension supports
Petrol models Lateral supports Support cushions M112 Preparing to remove the side support cushions of the powertrain suspension (M112) Installation details of the side...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More similar sections for repairing other models

☛ Power unit: Engine repair car Mercedes W168 (1997-2004)
☛ Gasoline engines: Engine repair car Mercedes W210 (1996-2002)
☛ Power unit: 6-cylinder I6 engine car Mercedes W116 (1972-1980, petrol)
☛ Diesel engine OM646: Engine repair car Mercedes Vito 2 (2003-2014, diesel)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

W463 (1999-2019)