Car rear suspension Mercedes G-Class (W463)

General information about the rear suspension
The rear suspension is also independent with a solid axle and is organized similarly to the front (see Section General information ). Rear suspension layout (see also...

Removal and installation of the rear axle assembly
Rear Axle Assembly Installation Details 1, 2 - Bolts for fastening the diagonal rod to the bridge and frame; 3 - Diagonal bar; 4 - Electrical wiring connector; 5 -...

Removal, checking and installation rear shock absorbers
Upper shock absorber support design Location of the lower support of the rear shock absorber 1. Loosen the nut (1), then remove the plate (2) with the rubber bushing (3)...

Removal and installation front suspension springs
Attention! The suspension springs must be replaced in pairs for each axle! 1. If equipped, disconnect the brake pressure regulator rod from the rear axle housing (see...

Removal and installation the rear anti-roll bar
Attention! Self-locking fasteners must be replaced! 1. Loosen the fastening nuts (1) and disconnect the clamps securing the anti-roll bar to the trailing arms. Assess...

Removal and installation trailing arms
Rear Suspension Trailing Arm Installation Details 1 - Trailing arm; 2 - Nut; 3 - Bolt 1. Immobilize the vehicle. 2. Release the parking brake cable from the intermediate...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More similar sections for repairing other models

☛ Chassis: Rear suspension car Mercedes W123 (1976-1985)
☛ Chassis: Rear suspension car Mercedes W163 (1997-2005)
☛ Chassis: Rear suspension car Mercedes W126 (1979-1991, petrol)
☛ Chassis: Rear suspension car Mercedes Vito 1 (1996-2003)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

W463 (1999-2019)