1 - Torque converter housing; 6 - Multi-disc brake B1; 6a - M6x32 bolts (11 pieces); 7 - Oil pump; 7a - M8x35 bolts (7 pieces); 8 - Intermediate plate
Removing
1. Remove multi-plate clutches K1, K2 and K3.
2. Remove the bolts 7a and remove the oil pump 7. Remove the two opposite bolts in the oil pump housing and remove the oil pump from the torque converter housing by lightly tapping with a plastic hammer.
3. Unscrew the ba bolts and remove the B1 6 multi-disc brake from the torque converter housing. Loosen the two opposing bolts in the B1 multi-disc brake and remove it from the torque converter housing by lightly tapping with a plastic mallet.
4. Disconnect the intermediate plate 8 from the torque converter housing 1.
Installation
1. Install the intermediate plate 8 on the torque converter housing 1. The intermediate plate 8 can be used several times.
2. Screw the mounting bolts of the multi-disc brake B1 6 in the torque converter housing 1. The installation position of the multi-disc brake B1 relative to the torque converter housing is determined by the guide pin on the multi-disc brake B1 (arrow).
3. Install oil pump 7 and tighten its fastening bolts.
4. Install multi-plate clutches K1, K2 and K3. The illustration shows oil passage E for clutch K1.