Clutch and cardan shaft of the car Mercedes S-Class (W116)

Clutch — General Information and Removal
The clutch is single-disk, dry, with a central pressure diaphragm spring. The clutch drive is hydraulic with a master and slave cylinder. The pressure plate and...

Clutch repair
Check the clutch pressure plate and housing for their relative movement and absence of damage. If damaged, replace the assembly. Check the springs of the driven disk...

Clutch installation
The driven clutch disc for diesel engines is distinguished by the installation of an additional damper on the torsional damper to reduce noise when the engine is running...

Clutch release drive
To engage or disengage the clutch, the slave cylinder pusher moves the clutch release fork, which moves the clutch release sleeve along the guide of the front gearbox...

Checking the wear of the clutch driven disc linings (in assembled condition)
The clutch housing design does not provide external access to the clutch release system components. Therefore, the wear of the driven disk linings is determined on the...

Removal and installation the master cylinder
All car models are equipped with working cylinders of different diameters, which must be taken into account when replacing the master cylinder. Fig. 167 shows the...

Removal and installation the slave cylinder
Use a wrench to loosen the pipeline fastening to the working cylinder and plug the hole in the pipeline to prevent brake fluid from leaking out. Unscrew the two bolts...

Checking the free play of the clutch and suspension pedal
Check the dimension "a" of the spring in Fig. 167. Adjust the nut and lock nut on the spring rod. Check the clearance "b" between the pushrod and the master cylinder...

Bleeding the hydraulic drive
At the service station, a special device is used to bleed the hydraulic system. In the description below, the brake hydraulic system is used to bleed the clutch drive...

Disassembly and assembly of synchronizer of manual transmission
Wrap the synchronizer coupling with a rag and squeeze it out of the hub together with the driver. Check the wear of all parts. Remove the locking rings and drivers from...

Removal and installation the cardan transmission
The cars are equipped with a cardan transmission consisting of two cardan shafts and an elastic coupling on the front shaft. The cardan shafts on cars of later...

Removal and installation the intermediate support bearing of the cardan transmission
If necessary, mark the cardan shafts as shown in Fig. 205. Remove the mounting ring from the groove and remove the front protective cover. Using a puller, remove the...

Adjusting the front wheel alignment
The data for adjusting the front wheels is in the size and adjustment data tables. Before measuring and adjusting, make sure that the steering, wheel suspension and hub...

Clutch specifications
Clutch housing assembly No model 280/280 SE — 001 250 4204 model 350 SE/450 SE - 002 250 2204 Information on the dimensions of the clutch parts for repair is not...

Tightening torques for threaded connections
Cardan transmission Self-locking nuts for fastening the elastic coupling: 280/280 SE/ 350 SE - 45 Nm 450 SE — 65 Nm Intermediate support mounting bolts - 25 Nm Clamping...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More similar sections for repairing other models

☛ Transmission: Clutch car Mercedes W168 (1997-2004)
☛ Transmission: Clutch car Mercedes 190 (W201) (1982-1993)
☛ Transmission: Clutch car Mercedes W210 (1996-2002)
☛ Transmission: Clutch car Mercedes W163 (1997-2005)
☛ Transmission: Clutch car Mercedes Vito 2 (2003-2014, diesel)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

W140 (1991-1998)