The driven clutch disc for diesel engines is distinguished by the installation of an additional damper on the torsional damper to reduce noise when the engine is running at idle speed.
The clutch is installed in the reverse order of removal. When installing, align the marks on the flywheel and clutch housing. A special mandrel or an old gearbox drive shaft is used to install the driven disk. Place the driven disk on the mandrel and insert the mandrel into the bearing hole in the flywheel.
Tighten the mounting bolts evenly crosswise and tighten to 20 Nm. Install the gearbox.
Clutch installation (Mercedes-Benz S-Class W116)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
The article has been verified: Panova Maya Vladimirovna
More similar articles for repairing other models
☛ General description of the clutch Mercedes W168 (1997-2004)
☛ Hydraulic fan clutch — removal and installation Mercedes W202 (1993-2000)
☛ Checking the cooling fan drive clutch Mercedes W123 (1976-1985)
☛ Description of the clutch design Mercedes W163 (1997-2005)
☛ Viscous fan clutch Mercedes Sprinter (1995-2000, diesel)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Introduction to guide
- User manual
- Maintenance
- Power unit
- Engine repair
- Cooling and heating systems
- Power and exhaust systems
- Ignition and control system
- Charge and launch systems
- Transmission
- Automatic gearbox
- Drive shafts
- Chassis
- Brake system
- Front suspension
- Rear suspension
- Steering
- Body
- Body elements
- Electrical equipment
- Equipment and devices
- Electrical circuits
- User manual
- Controls and instruments
- Driving and operation
- Maintenance
- Power unit
- Petrol engine V6
- Petrol engine V8
- Petrol engine V12
- Diesel engine OM603
- Diesel engine OM606
- Cooling system
- Power supply and injection system
- Control system HFM-SFI
- Control system LH-SFI
- Control systems ME-SFI
- Diesel control system
- Ignition system
- Charge and launch system
- Transmission
- Mechanical gearbox 717.438
- Mechanical gearbox 717.454
- Automatic gearbox 722.5
- Automatic gearbox 722.6
- Clutch and drive shafts
- Differential
- Chassis
- Brake system
- Steering
- Front suspension
- Rear suspension
- Body
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Electrical circuits
- General information
- Introduction to guide
- Power unit
- 8-cylinder V8 engine
- 6-cylinder I6 engine
- Cooling and lubrication system
- Power system (carburetor)
- Fuel injection system
- Ignition system
- Transmission
- Clutch and cardan
- Car gearbox
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Electrical equipment
- Power devices
- Electrical circuits