Car front suspension Mercedes S-Class (W116)

Removal and installation the shock absorber
Each half of the front suspension consists of one upper and one lower wishbone, a hydraulic telescopic shock absorber and a tie rod mounted on elastic supports between...

Removal and installation the front suspension spring
Unscrew the fastening of the upper part of the shock absorber. Place the front of the car on stands and remove the front wheels. Using a suitable device, compress four...

Removal and installation the front suspension
Fig. 210 shows half of the front suspension with the hub and wheel. Fig. 210. Half of the front suspension. 1 - steering knuckle, 2 - upper transverse arm, 3 - anti-roll...

Adjusting the axial clearance of wheel hub bearings
Place the front of the car on stands. Remove the front wheel. Secure the brake disc to the hub using two wheel mounting bolts. Without damaging the surface of the...

Removal and installation the hub
Raise the front of the vehicle and remove the front wheel. Using a puller as shown in Fig. 214, remove the hub cap. Remove the spring contact to eliminate radio...

Replacing bearings in the hub
According to Fig. 217: Remove the inner ring (6) together with the outer bearing rollers from the pivot axle. Remove the oil seal (4) and remove the inner ring (5)...

Removal and installation the steering knuckle
Place the front of the car on stands and remove the wheel. Unscrew the brake caliper mount and hang it on a piece of wire next to the front suspension. Remove the brake...

Replacing ball joints
The upper and lower ball joints consist of a ball pin and a synthetic liner. The lower ball joint housing is pressed into the steering knuckle, the upper ball joint is...

Adjusting the camber and caster angle of the steering axis
The adjustment of the camber and longitudinal angle of the steering axis of the front wheels is carried out together. The camber adjustment is carried out by turning the...

Determining the difference in rotation angles
Turn the inner front wheel by 20° and determine the angle of rotation of the outer front wheel. The measurement is carried out on the pivot supports to adjust the...

Front Suspension Specifications
Installing front suspension springs (rubber front spring mounts) Front suspension spring rubber mounts: height 8 mm - part no. 115 321 4884 height 13 mm - part no. 115...

Tightening torques for threaded connections
Suspension Front suspension stabilizer bar mounting bolts or nuts — 20 - 25 Nm Rear suspension stabilizer bar mounting bolts - 65 Nm Ball joints of connecting rods of...

Wheel Specifications and Wheel Alignment
Standard disc wheels: 280/280 SE 350 SE/450 SE Designation: 6Jx14H2 6,1/2Jx14H2 Part Number: 108 400 1402 108 400 0802 Disc wheel centering: central Aluminum alloy disc...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More similar sections for repairing other models

☛ Chassis: Front suspension car Mercedes W123 (1976-1985)
☛ Chassis: Front suspension car Mercedes W463 (1999-2019)
☛ Chassis: Front suspension car Mercedes W163 (1997-2005)
☛ Chassis: Front suspension car Mercedes Vito 2 (2003-2014, diesel)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

W140 (1991-1998)