Car front suspension Mercedes Vito 2 (W639)

Front wheel suspension
The front suspension is a single-lever MacPherson type suspension. The lower suspension arm is triangular in plan. The vehicle's braking forces are absorbed directly by...

Front suspension arm
The front suspension arm is attached to the subframe using two silent blocks. The lever is attached to the steering knuckle using a ball joint, which is riveted to the...

Front control arm and steering knuckle
VN 5.003 1. Steering knuckle with hub assembly; 2. Ball joint; 3. Sheathing sheet; 4. Protective plate; 5. Screw; 6. Lever; 7. Silent block; 8. Bolt; 9. Nut; 10. Bolt;...

Fastening the steering knuckle to the shock absorber strut
The steering knuckle is attached to the shock absorber strut using two bolts, the upper one of which is eccentric and serves to adjust the camber of the wheels. VN 5.005...

Anti-roll bar
VN 5.006 1. Front subframe 2. Bracket 3. Rubber bushing of the stabilizer Tightening torques for stabilizer mounting bolts M8: 20 Nm + 60°. M10: 60 Nm. VN 5.007...

Fastening the stabilizer bar
The anti-roll bar is connected to the shock absorber struts using two rods. There are two spherical joints at both ends of the rod. The lower hinge is attached to the...

Shock absorber strut
The composition of the shock absorber strut and the assembly sequence are shown in Figure VN 5.009. VN 5.009 1. Shock absorber; 2. Nut; 3. Washer; 4. Washer; 5. Lower...

General information on checking wheel alignment angles
VN 5.027 Before checking the wheel alignment angles, the vehicle should be checked for compliance with the conditions for such a check. - Condition of wheel tyres:...

Checking and adjusting the front wheel alignment
To check the front wheel alignment, set the wheels to the straight-ahead position. To do this, use the clamp (1) and the mounting rod (2). VN 5.030 1. Steering wheel...

Checking and adjusting the camber and longitudinal tilt of the wheel pivot axis
VN 5.034 Camber and caster angles of the wheel pivot axis 1. Upper eccentric bolt; 2. Lower bolt securing the steering knuckle to the shock absorber strut; a. Wheel...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More similar sections for repairing other models

☛ Chassis: Front suspension car Mercedes W123 (1976-1985)
☛ Chassis: Front suspension car Mercedes W463 (1999-2019)
☛ Chassis: Front suspension car Mercedes W163 (1997-2005)
☛ Chassis: Front suspension car Mercedes W220 (1998-2005)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

Vito 1 (1996-2003)