Car engine lubrication system Mercedes Sprinter I (903)

Purpose of the engine lubrication system
The main purpose of the engine lubrication system is to reduce wear on the engine's rubbing parts: pistons, cylinders, crankshaft bearings, and valve timing mechanism....

Checking the oil level
Figure 117. Location of the oil dipstick on a 2.3L engine (208D, 308D, 408D) Figure 118. Location of the oil dipstick (1) and oil filler cap (2) on a 2.9 L engine (212D,...

Engine oil consumption
If the oil level drops, then you have to top up the oil, you should take the time to determine the oil consumption: carefully pour oil exactly up to the top mark; after...

Selecting and replacing engine oil
When purchasing oil, you must follow two basic rules. Oil quality: Mercedes has its own lubricant research laboratory, where all brands of oil sold are regularly tested....

Causes of sediment formation in oil
The introduction of modern injection systems and catalytic converters leads to increased sediment formation in engine oil during operation of engines of all...

Oil change at the service
The engines of this car are quite suitable for a quick and neat oil change procedure using a suction pump, the intake pipe of which is inserted into the hole for the oil...

Do-it-yourself engine oil change
A fairly powerful suction pump is used to pump oil through the dipstick tube. There are electric and manual devices available for sale. Some devices are designed to be...

Brief description of the lubrication system
The required pressure in the lubrication system is created by a gear-type oil pump, driven by a separate chain from the crankshaft sprocket. The chain is equipped with a...

Removal and installation the oil pump
To remove and install the oil pump, you must perform the following operations: remove the oil pan ( see subsection 3.5 ); Figure 122. Oil pump drive sprocket mounting...

Removal and installation the oil pan
Mercedes service stations use special devices to support the engine when removing the crankcase. After all, this requires dismantling the cross beam, as a result of...

Removal and installation the oil filter
Figure 128. Location of the oil filter on a 2.3 liter engine Figure 129. Oil filter parts (2.9L engine): 1 - filter element; 2 — filter housing cover; 3 - sealing...

Oil radiator — removal and installation
Figure 130. The oil radiator (1) is located at the rear of the engine Figure 131. Oil radiator mounting parts: 1 - Hex bolt; 2 — mounting bracket; 3 - bolt; 4 - oil...

Oil dipstick
Figure 117. Location of the oil dipstick on a 2.3L engine (208D, 308D, 408D) Figure 118. Location of the oil dipstick (1) and oil filler cap (2) on a 2.9 L engine (212D,...

Turbodiesel engine oil lines
Figure 133. Details of the lubrication system of the air compressor and turbocharger on a turbodiesel engine: 1 - bolt; 2 - sealing ring; 3 - return oil line from the...

Lubrication System Specifications
Type - Pressurized, with gear oil pump Filling capacity of four-cylinder engine, l: full (dry engine) — 7,3 when changing oil and filter - 6.5 Filling capacity of...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More similar sections for repairing other models

☛ Power unit: Lubrication system car Mercedes W202 (1993-2000)
☛ Gasoline engines: Lubrication system car Mercedes W210 (1996-2002)
☛ Power unit: Lubrication system car Mercedes W126 (1979-1991, petrol)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

Vito 1 (1996-2003)