Rear axle and cardan car Mercedes Sprinter I (903)

Rear Axle and Propeller Shaft — General Description
Depending on the modification, different types of rear axles are installed on the vehicle. It is also necessary to take into account the difference between versions with...

Removal and installation the rear axle (for models without ABS)
Figure 220. Rear axle of a vehicle without ABS: 1 — spring U-bolt nut, 100–120 N·m; 2 — spring; 3 - spring ladder; 4 - rubber stop pad; 5 — parking brake cable; 6 - rear...

Removal and installation the rear axle (for models with ABS)
Figure 227. Location of speed sensors Removal and installation are carried out in the order, described above , with the difference that the ABS speed sensor must be...

Disassembling the rear axle
Since repair of the rear axle and differentials requires special tools and equipment, this manual does not cover repair procedures. To visually check the condition of...

Removal and installation of drive axle shafts
Figure 228. Removing and installing the rear axle half shaft: 1 — axle shaft housing; 2 - cuff (always subject to replacement); 3 — half-shaft; 4 - tension spring; 5 —...

Disassembling the drive axle shaft
Figure 231. Axle shaft parts: 1 — axle shaft; 2 — bearing cap; 3 - cuff (always subject to replacement); 4 - gasket (always subject to replacement); 5 - slotted nut; 6 -...

Drive gear sleeve
If oil leaks are detected in the area of the drive gear, behind the gearbox flange, the sealing elements must be replaced. This can be done without removing the gear....

Checking the oil level in the rear axle housing and changing the oil
The oil filler hole in the gearbox cover is used to check the oil level. Before unscrewing the plug, thoroughly clean the area around it. To unscrew the plug, you need a...

Cardan shaft — removal and installation
Removing and installing the cardan shaft is not difficult. The shaft flanges are bolted on one side to the gearbox flange and on the other side to the rear axle flange....

Rear Axle and Suspension Specifications
Bridge designation: for 208D and 212D, series 901 and 902 - HL0/14-1,7 (741.407) 308D and 312D, series 903 - HL0/15-2.2 (741.408) 412D, series 904 - HL0/3.2 (741.130)...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

Vito 1 (1996-2003)