Removal and installation the rear axle (for models with ABS) (Mercedes-Benz Sprinter 903)

Figure 227. Location of speed sensors

Removal and installation are carried out in the order, described above, with the difference that the ABS speed sensor must be disconnected from the axle at the rear of the brakes. Figure 227 shows the location of the connector.

[Information copied from the website MERCEDESMAN.ru]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article has been verified: Levin Kirill Glebovich

Share with friends:

◀ Previous

Mercedes Sprinter / Rear axle and cardan

Next ▶

Removal and installation the rear axle (for models without ABS)
Rear Axle and Propeller Shaft — General Description

Disassembling the rear axle
Removal and installation of drive axle shafts
Disassembling the drive axle shaft
Drive gear sleeve
Checking the oil level in the rear axle housing and changing the oil

More similar articles for repairing other models