Car headlights and lighting Mercedes Sprinter I (903)
The operation of the outdoor lighting devices of the Mercedes-Benz Sprinter is controlled by an electronic system, which, if any lamp fails, immediately gives a warning signal.
Checking lamps This task is performed by an electronic device located in the relay box. Wires of controlled lamps pass through the device. If there is no current flowing to the lamp,...
Replacing outdoor lamps Replacing headlights Pic. 318. Block headlight headlight from the back (with arrangement of lamps and contacts): 1 - high beam lamp, H1, 12 V, 55 W; 2 - low beam lamp,...
Headlight housing replacement Since the replacement of headlights always involves their subsequent adjustment, the following operations are described taking into account the mandatory adjustment of...
Replacing the front direction indicators Pic. 322. Removal and installation of the front direction indicator: 1 - latch tab; 2 - lamp holder Disconnect the battery before replacing. Replacement is carried out...
Headlight adjustment Adjustment is carried out from the rear side of the headlights using an optical device. It is better to adjust the headlights at the service station. For...
Headlight range adjustment Additionally, a pneumatic headlight range adjustment can be installed. Adjustment is carried out by a rotary switch next to the light switch, depending on the degree of...
Headlight cleaners In vehicles equipped with headlight cleaners, a washer reservoir with two pumps is installed in the engine compartment. Each of the cleaner leads is equipped with its...
Rear lights Pic. 325. Rear light The rear light consists of a lamp holder, a reflector and a diffuser cover made of colored plastic. The cover is installed outside on the body...
Rear lights of a different design Replacing the rear lights in this case must be carried out in the following order: Pic. 327. Replacing lamps in a rectangular rear light: 1 - fastening screws; 2 - side...
Direction indicators and alarms If you press the red hazard warning switch with the ignition off, all four direction indicators and the transparent button of the switch itself will flash in the same...
Side turn signal repeaters Depending on the modification, small or large side turn signal repeaters can be installed. Their removal and installation are different. Pic. 328. Removing a small...
License plate light Pic. 329. Removing a large turn signal repeater To replace the lamp, unscrew the lamp with a small screwdriver, remove the cover and remove the lamp from the holder....