When adjusting the toe, the steering was not set to the middle position.
The bipod is incorrectly installed on the steering shaft.
Bipod, tie rods or swing arm bent.
Vehicle Position Check
Checking the position of the car is carried out by measuring the position of the transverse levers of the front suspension with the device 116 589 13 21 00 (pic. 221). The work is done at the service station. For adjustment, rubber pads of various thicknesses are used. If necessary, replace the front suspension springs.
Pic. 221. Measurement of the position of the transverse levers of the front suspension.
1 - a device for measuring the position of the transverse levers,
2 - lower transverse arm of the front suspension.