Manual gearbox Mercedes S-Class (W126)
Removal and installation the gearbox
The gearbox can be removed without removing the engine. Removal is necessary to replace or repair the gearbox or clutch. However, since it is in no case recommended to...
The gearbox can be removed without removing the engine. Removal is necessary to replace or repair the gearbox or clutch. However, since it is in no case recommended to...
Gear shift cover
Removal Drain the oil from the gearbox. Remove the gear shift lever for reverse gear after loosening the bolt on the double plane of the shift shaft. Loosen the bolts...
Removal Drain the oil from the gearbox. Remove the gear shift lever for reverse gear after loosening the bolt on the double plane of the shift shaft. Loosen the bolts...
Removal and installation the front gearbox cover
Remove the clutch release bearing from the guide tube on the front gearbox cover. Pull it off the clutch housing and remove the clutch release fork. Remove the clutch...
Remove the clutch release bearing from the guide tube on the front gearbox cover. Pull it off the clutch housing and remove the clutch release fork. Remove the clutch...
Removal and installation the rear cover of the gearbox
Release the splined nut securing the propeller shaft flange from the safety catch, then loosen and unscrew it using the socket wrench attachment 115 589 01 07 00,...
Release the splined nut securing the propeller shaft flange from the safety catch, then loosen and unscrew it using the socket wrench attachment 115 589 01 07 00,...
Reverse gear — removal and installation
If the installation work is limited exclusively to work with the reverse gear, then removing the gearbox is not required. Removal Unscrew the gearbox cover from the...
If the installation work is limited exclusively to work with the reverse gear, then removing the gearbox is not required. Removal Unscrew the gearbox cover from the...
Adjusting the gear shift lever
Disconnect the gear shift rods from the rack levers on the gear shift lever after removing the locking pins. Secure the three intermediate shift levers under the shift...
Disconnect the gear shift rods from the rack levers on the gear shift lever after removing the locking pins. Secure the three intermediate shift levers under the shift...
Checking the oil level in a manual transmission
The oil filled into the gearbox by the manufacturer should not be replaced. It is necessary to check the oil level every 20,000 km. To check the oil level, the oil...
The oil filled into the gearbox by the manufacturer should not be replaced. It is necessary to check the oil level every 20,000 km. To check the oil level, the oil...
Tightening torques for threaded connections
Clutch and manual transmission Engine 280S and 280SE 380SE and 500SE 350SE and 450SE Pressure Plate Bolts 25 - 25 Splined nut for fastening the cardan flange with three...
Clutch and manual transmission Engine 280S and 280SE 380SE and 500SE 350SE and 450SE Pressure Plate Bolts 25 - 25 Splined nut for fastening the cardan flange with three...
Cross-section of a 5-speed manual transmission
1 - flywheel; 2 - driven clutch disc; 3 - clutch release bearing; 4 - Front gearbox cover; 5 - main (secondary) shaft; 6 - gearbox casing; 7 - speedometer drive; 8 -...
1 - flywheel; 2 - driven clutch disc; 3 - clutch release bearing; 4 - Front gearbox cover; 5 - main (secondary) shaft; 6 - gearbox casing; 7 - speedometer drive; 8 -...
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
More similar sections for repairing other models
☛ Transmission: Transmission car Mercedes W168 (1997-2004)
☛ Transmission: Car gearbox car Mercedes W202 (1993-2000)
☛ Transmission: Mechanical gearbox car Mercedes W123 (1976-1985)
☛ Transmission: Mechanical gearbox car Mercedes W163 (1997-2005)
☛ Transmission: Mechanical gearbox car Mercedes Vito 1 (1996-2003)
Link in different formats to this section
TEXTHTMLBB Code
- General information
- Introduction to guide
- User manual
- Maintenance
- Power unit
- Engine repair
- Cooling and heating systems
- Power and exhaust systems
- Ignition and control system
- Charge and launch systems
- Transmission
- Automatic gearbox
- Drive shafts
- Chassis
- Brake system
- Front suspension
- Rear suspension
- Steering
- Body
- Body elements
- Electrical equipment
- Equipment and devices
- Electrical circuits
- User manual
- Controls and instruments
- Driving and operation
- Maintenance
- Power unit
- Petrol engine V6
- Petrol engine V8
- Petrol engine V12
- Diesel engine OM603
- Diesel engine OM606
- Cooling system
- Power supply and injection system
- Control system HFM-SFI
- Control system LH-SFI
- Control systems ME-SFI
- Diesel control system
- Ignition system
- Charge and launch system
- Transmission
- Mechanical gearbox 717.438
- Mechanical gearbox 717.454
- Automatic gearbox 722.5
- Automatic gearbox 722.6
- Clutch and drive shafts
- Differential
- Chassis
- Brake system
- Steering
- Front suspension
- Rear suspension
- Body
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Electrical circuits
- General information
- Introduction to guide
- Power unit
- 8-cylinder V8 engine
- 6-cylinder I6 engine
- Cooling and lubrication system
- Power system (carburetor)
- Fuel injection system
- Ignition system
- Transmission
- Clutch and cardan
- Car gearbox
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Electrical equipment
- Power devices
- Electrical circuits

