Gearbox design 1. The lower protective casing of the engine; 2. cardan shaft; 3. Screen; 4. Self-tapping screw; 5. Hex socket bolt (replace each time); 6. Washer (replace each time);...
Gearbox — removal, installation and adjustment The gearbox can be removed without removing the engine. But in most cases, removal is required only when it is necessary to replace the gearbox, rebuild or replace the...
Automatic transmission C-class engines are optionally equipped with an automatic transmission. The automatic transmission has three selective speed preselection ranges that are automatically...
Towing vehicles equipped with automatic Selector lever position: "N". Maximum towing speed: 50 km/h! Maximum towing distance: 50 km! For longer distances, the vehicle must be raised at the rear, or the...
Checking the oil level in an automatic transmission For the normal functioning of the automatic transmission, it is extremely important to maintain the prescribed oil level. Therefore, the check should be carried out with...
Transmission oil and filter — change The transmission oil filling is usually changed every 60,000 km of the car, and the filter is also replaced at the same time. Under severe operating conditions (towing a...
Control pressure cable The adjustment of the control pressure cable must be checked in the following cases and corrected if necessary: required when installing a throttle cable; if there are...
Gearshift rod Attention! The vehicle must be on wheels during installation. 1. Disconnect the shift rod (5) from the gear lever. 2. Put the selector lever (6) into position "N". 3....
Features of the operation of an automatic transmission All you need is to learn the position of the transmission control selector lever and its main positions: P - parking (parking brake); R - reverse (reverse); N - neutral;...