Power supply system (carburetor) of the car Mercedes 190 (W201)

Technical data
Gasoline pump Type - Mechanical, driven by an eccentric cam on an intermediate shaft, via a pushrod Feed pressure - 0.20-0.40 bar Productivity - 0.15 liters in 10...

Basic information and precautions
Basic information On all carburetor models, the main parts of the fuel system are a Stromberg or Pierburg type carburetor, a gas tank, a mechanical fuel pump, metal and...

Air cleaner and filter element — removal and installation
Removal 1. Disconnect the air intake hose that runs from the air cleaner to the front of the engine compartment. 2. Disconnect the warm air intake from the base of the...

Air Cleaner Temperature Control System — Checking and Replacing Parts
Examination 1. Pull off the air intake hose that runs from the air cleaner to the front of the engine compartment. 2. Loosen the screws and disconnect the heater flap...

Fuel pump — removal and installation
Removal Note: This operation involves disconnecting the fuel lines - refer to the safety precautions in paragraph 1 and in the section " Safety first! " at the beginning...

Fuel level indicator sensor — removal and installation
Warning: When handling parts of the power supply system, observe the precautions outlined in paragraph 1. The following operation must be carried out in a...

Gas tank — removal and installation
Warning: This operation must be carried out in a well-ventilated area. Removal 1. Before starting work, empty the gas tank. This is best done after waiting until almost...

Throttle Cable — Removal, Installation and Adjustment
Removal 1. Working in the engine compartment, remove the square retainer (see fig. 7.1) and disconnect the throttle cable from the carburetor guide lever. Release the...

Stromberg 175 CDT Carburetor — Basic Information and Parts Replacement
Basic information 1. Before disassembling the carburetor, make sure that the ignition timing is correct. The spark plugs must be clean and their gap correctly adjusted....

Pierburg 2E-E carburetor fuel system — basic information and replacement of parts
Basic information 1. Before disassembling the carburetor, make sure that the ignition timing is correct. The spark plugs must be clean and their spark gap correctly...

Carburetor — removal and installation
Removal 1. Before starting work, make sure the engine is completely cool. Disconnect the negative battery terminal. 2. Refer to paragraph 2 and remove the air cleaner....

Intake manifold — removal and installation
Removal 1. Disconnect the negative battery terminal. 2. Contact Chapter 1A and drain the coolant. 3. Remove the carburetor as described in paragraph 10 . 4. Disconnect...

Intake Manifold Heater — Removal and Installation
Removal 1. Disconnect the negative battery terminal. 2. Disconnect the plug from the manifold heater connector. 3. Where required, loosen the bolts and remove the intake...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

190 (W201) (1982-1993)