Automatic car gearbox Mercedes 190 (W201)
Pressure control cable — adjustment
Carburetor engines 1. Remove the air cleaner as described in Chapter 4 , then check that the carburetor throttle lever rests on the idle speed adjustment screw. If not,...
Carburetor engines 1. Remove the air cleaner as described in Chapter 4 , then check that the carburetor throttle lever rests on the idle speed adjustment screw. If not,...
Technical data
General Transmission code - 722.4 Gearbox fluid Type - Automatic transmission fluid approved by Mercedes-Benz Tightening torques for connections, Nm Cross beam to the...
General Transmission code - 722.4 Gearbox fluid Type - Automatic transmission fluid approved by Mercedes-Benz Tightening torques for connections, Nm Cross beam to the...
Basic information about automatic transmission
All models covered in this guide can be equipped with a 5-speed automatic transmission. The gearbox includes a torque converter, planetary gear, hydraulic clutch and...
All models covered in this guide can be equipped with a 5-speed automatic transmission. The gearbox includes a torque converter, planetary gear, hydraulic clutch and...
Gear Selector Lever — Removal and Installation
Removal 1. Disconnect the negative battery terminal. 2. Apply the parking brake, then raise the front of the vehicle and support it on stands (see " Lifting the car and...
Removal 1. Disconnect the negative battery terminal. 2. Apply the parking brake, then raise the front of the vehicle and support it on stands (see " Lifting the car and...
Shift Lever Rod — Adjustment, Removal and Installation
Adjustment 1. To perform the adjustment, the vehicle must be placed on its wheels. 2. Working from underneath the vehicle, remove the metal retainer and disconnect the...
Adjustment 1. To perform the adjustment, the vehicle must be placed on its wheels. 2. Working from underneath the vehicle, remove the metal retainer and disconnect the...
Starter Lock/Reverse Light Switch — Removal, Installation and Adjustment
Removal 1. Raise the hood and position a thin sheet of metal (approximately 300 mm in area) at the rear of the engine compartment bulkhead to protect the bulkhead...
Removal 1. Raise the hood and position a thin sheet of metal (approximately 300 mm in area) at the rear of the engine compartment bulkhead to protect the bulkhead...
Automatic transmission — removal and installation
Removal 1. Raise the hood and position a thin sheet of metal (approximately 300 mm in area) at the rear of the engine compartment bulkhead to protect the bulkhead...
Removal 1. Raise the hood and position a thin sheet of metal (approximately 300 mm in area) at the rear of the engine compartment bulkhead to protect the bulkhead...
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
More similar sections for repairing other models
☛ Transmission: Automatic gearbox car Mercedes W124 (1984-1995)
☛ Transmission: Automatic gearbox car Mercedes W463 (1999-2019)
☛ Transmission: Automatic gearbox car Mercedes W163 (1997-2005)
☛ Transmission: Automatic gearbox 722.6 car Mercedes W140 (1991-1998)
☛ Transmission: Automatic gearbox car Mercedes Sprinter (1995-2000, diesel)
Link in different formats to this section
TEXTHTMLBB Code
- General information
- Introduction to guide
- User manual
- Maintenance
- Power unit
- Gasoline engines
- Diesel engines
- Cooling system
- Ventilation and heating
- Supply system
- Injection system (gasoline)
- Injection system (diesel)
- Exhaust system
- Ignition and control system
- Charge and launch systems
- Transmission
- Mechanical gearbox
- Automatic gearbox
- Clutch and drive shafts
- Differential
- Chassis
- Brake system
- Car suspension
- Steering
- Body
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Lighting system
- Electrical diagrams (2000)
- Electrical diagrams (since 2001)
- General information
- User manual
- Driving a car
- Car care
- Maintenance
- Power unit
- Gasoline engines
- Diesel engines
- Lubrication system
- Cooling system
- Heating and ventilation
- Ignition system
- Fuel system
- Injection system (gasoline)
- Injection system (diesel)
- Exhaust system
- Transmission
- Clutch
- Car gearbox
- Chassis
- Suspension, wheels and tires
- Steering
- Brake system
- Body
- Exterior (external elements)
- Interior (internal elements)
- Doors and windows
- Electrical equipment
- Equipment and devices
- Power devices
- Lighting system
- Electrical circuits
- General information
- Introduction to the guide
- Operation and care
- Maintenance (gasoline)
- Maintenance (diesel)
- Troubleshooting
- Power unit
- Petrol engine I4
- Petrol engine V6
- Diesel engines
- Engine overhaul
- Cooling and heating
- Power system (carburetor)
- Injection system (gasoline)
- Injection system (diesel)
- Exhaust system
- Charge and start system
- Ignition system (I4)
- Ignition system (V6)
- Diesel heating system
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Cardan shaft and axle shafts
- Chassis
- Brake system
- Car suspension
- Steering
- Body
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits