Front door — removal and installation Driver's door 1. Coating; 2. Sealing gasket; 3. A-pillar bolts 4. Protective sleeve; 5. Centering bolt Removing 1. Fully lower the driver's door window. 2. Press Cover...
Rear door — removal and installation Removing 1. Fully lower the door glass. 2. Open the front door and, with the rear door closed, unscrew the hinge bolts (1). 3. Protective sleeve (2) wring out from the...
Front door handle — removal and installation 1. Door handle; 2. Lock cylinder guide; 3. Rotary rod; 4. Gasket; 5. Gasket 6. 4mm Allen screw; 7. Retaining bracket for bolt; 8. Support bracket; 9. Screws Removing 1....
Rear door handle — removal and installation The rear door handle is similar in design to the front door handle, below are the differences first. Removing 1. Remove the door seal at the height of the door lock from...
Door lock — removal and installation Removing Rear door lock 1 - a rod for actuating the door from the inside; 2 - locking mechanism; 3 - door lock; 4, 5 - clamps; 6 - vacuum pipeline for ABS; 7, 8 - bolts...
Interior door trim — removal and installation Driver's door 1. Power window handle; 2. Lock socket; 3. Recess for the handle; 4. Coating 5. Door lining Note: Work must be carried out on the rear doors accordingly....
Front power window — removal and installation Removing 1. Remove an internal covering of a door. 2. Carefully remove the sealing film. Be careful: the film tears easily. 3. Lower the window glass as low as possible...
Front window glass — adjustment 1. Check the installation position of the glass when it is slightly opened. The gap from above must be uniform, from below the glass must enter the guide rail, otherwise...
Rear power window — removal and installation 1. Power window; 2. Slider; 3. Holes for fastening blind rivets; 4. Locking bracket; 5. Power window bus; 6. Lowered glass; 7. Blind rivet 4.8 mm Removing 1. Remove an...
Front door glass — removal and installation Attention! Some operating instructions are detailed in subsection 12.8. , so we recommend that you reread this section. Proceed accordingly for the tailgate window....
Power window motor — removal and installation Removing 1. Remove an internal covering of a door. 2. Carefully peel off the sealing film in the bottom area. Attention! The film breaks easily. 3. Disconnect the plug...