Technical data General System type - EZL Ignition coil Primary winding resistance - 1.0 ohm minimum Secondary winding resistance - 8-13 kOhm Distributor Type - Non-contact, camshaft...
General provisions The main elements of the EZL type ignition system are spark plugs (one for each cylinder), high voltage wires, distributor, electronic ignition coil and electronic...
Checking the ignition system Warning: The voltage generated by the electronic ignition system is significantly higher than in a conventional system. When the ignition system is on, special care must...
High voltage coil — removal and installation Removing 1. Disconnect the negative battery terminal. 2. On all models, the coil is bolted to the bracket in the front left of the engine compartment. Unzip and remove...
Distributor and slider — removal and installation Removing 1. The distributor is fixed longitudinally in front of the cylinder head. 2. Unfasten and remove the plastic cover. 3. Write down the order of installation of...
Ignition timing — check and adjustment 1. The EZL type ignition system is interrupted by an electronic signal generated by the crankshaft position sensor. The ignition control system determines the correct...