I4 engine ignition system Mercedes 190 (W201)
Technical data
System type 1.8 liter models - EZL 2.0 liter models with Stromberg carburetor - TSZ 2.0 liter models with Pierburg 2E-2 carburetor — EZL 2.0 litre fuel injected models:...
System type 1.8 liter models - EZL 2.0 liter models with Stromberg carburetor - TSZ 2.0 liter models with Pierburg 2E-2 carburetor — EZL 2.0 litre fuel injected models:...
Basic information about the ignition system
Models with EZL ignition system The main elements of the ignition system type EZL are spark plugs (one for each cylinder), high-voltage wires, distributor, electronic...
Models with EZL ignition system The main elements of the ignition system type EZL are spark plugs (one for each cylinder), high-voltage wires, distributor, electronic...
Checking the ignition system
Warning: The voltage generated by the electronic ignition system is significantly higher than that of a conventional system. Special care should be taken when the...
Warning: The voltage generated by the electronic ignition system is significantly higher than that of a conventional system. Special care should be taken when the...
High Voltage Ignition Coil — Removal and Installation
Models with EZL ignition system 1. The information is contained in Chapter 5B . Models with TSZ ignition system 2. Disconnect the negative battery terminal. 3. Pull off...
Models with EZL ignition system 1. The information is contained in Chapter 5B . Models with TSZ ignition system 2. Disconnect the negative battery terminal. 3. Pull off...
Distributor — removal and installation
Models with EZL type system Note: Unlike the TSZ contactless system, which is interrupted by a sensor inside the distributor, the EZL ignition system is switched...
Models with EZL type system Note: Unlike the TSZ contactless system, which is interrupted by a sensor inside the distributor, the EZL ignition system is switched...
Runner — removal and installation
Removal 1. Loosen the mounting screws and remove the distributor cover. 2. Remove the runner from the end of the distributor shaft (see fig. 5.2). Fig. 5.2. Remove the...
Removal 1. Loosen the mounting screws and remove the distributor cover. 2. Remove the runner from the end of the distributor shaft (see fig. 5.2). Fig. 5.2. Remove the...
Ignition timing — checking and adjustment
General Provisions Models with EZL ignition system 1. The EZL ignition system is interrupted by an electronic signal generated by the crankshaft position sensor. The...
General Provisions Models with EZL ignition system 1. The EZL ignition system is interrupted by an electronic signal generated by the crankshaft position sensor. The...
Ignition Control System Parts — Removal and Installation
Crankshaft speed sensor Removal 1. Disconnect the negative battery terminal. 2. Disconnect the sensor wire from the harness at the connector, which is located in the...
Crankshaft speed sensor Removal 1. Disconnect the negative battery terminal. 2. Disconnect the sensor wire from the harness at the connector, which is located in the...
This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
More similar sections for repairing other models
☛ Power unit: Ignition system car Mercedes W168 (1997-2004)
☛ Power unit: Ignition system (I4) car Mercedes W124 (1984-1995)
☛ Power unit: Ignition and control system car Mercedes W463 (1999-2019)
☛ Power unit: Ignition and control system car Mercedes W163 (1997-2005)
☛ Power unit: Ignition system car Mercedes W140 (1991-1998)
Link in different formats to this section
TEXTHTMLBB Code
- General information
- Introduction to guide
- User manual
- Maintenance
- Power unit
- Gasoline engines
- Diesel engines
- Cooling system
- Ventilation and heating
- Supply system
- Injection system (gasoline)
- Injection system (diesel)
- Exhaust system
- Ignition and control system
- Charge and launch systems
- Transmission
- Mechanical gearbox
- Automatic gearbox
- Clutch and drive shafts
- Differential
- Chassis
- Brake system
- Car suspension
- Steering
- Body
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Lighting system
- Electrical diagrams (2000)
- Electrical diagrams (since 2001)
- General information
- User manual
- Driving a car
- Car care
- Maintenance
- Power unit
- Gasoline engines
- Diesel engines
- Lubrication system
- Cooling system
- Heating and ventilation
- Ignition system
- Fuel system
- Injection system (gasoline)
- Injection system (diesel)
- Exhaust system
- Transmission
- Clutch
- Car gearbox
- Chassis
- Suspension, wheels and tires
- Steering
- Brake system
- Body
- Exterior (external elements)
- Interior (internal elements)
- Doors and windows
- Electrical equipment
- Equipment and devices
- Power devices
- Lighting system
- Electrical circuits
- General information
- Introduction to the guide
- Operation and care
- Maintenance (gasoline)
- Maintenance (diesel)
- Troubleshooting
- Power unit
- Petrol engine I4
- Petrol engine V6
- Diesel engines
- Engine overhaul
- Cooling and heating
- Power system (carburetor)
- Injection system (gasoline)
- Injection system (diesel)
- Exhaust system
- Charge and start system
- Ignition system (I4)
- Ignition system (V6)
- Diesel heating system
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Cardan shaft and axle shafts
- Chassis
- Brake system
- Car suspension
- Steering
- Body
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits