EZL ignition system The EZL ignition system includes spark plugs, high voltage wires, ignition distributor, ignition coil and ECU electronic control unit along with sensors, actuators and...
TFZ ignition system The TFZ ignition system works on the same principle as the EZL ignition system, with the following differences. In the TFZ ignition system, the ignition timing is...
Checking the ignition system Attention! When working on the ignition system with the ignition on, care must be taken, as you can get an electric shock from the high-voltage part of the ignition...
Ignition coil — removal and installation EZL ignition system See corresponding description in subsection 16.4 . TFZ ignition system Removing Removing the protective cover from the ignition coil Disconnecting...
Ignition distributor — removal and installation To remove the distributor cap on models with the TFZ ignition system, turn the cap screws a quarter of a turn. Alignment of the distributor rotor with the mark on the...
Distributor rotor — removal and installation Removing Removing the distributor rotor from the ignition distributor shaft 1. Remove the ignition distributor cap. 2. Pull the distributor rotor off the distributor...
Ignition advance angle EZL ignition system The EZL ignition system works based on the signal received from the crank angle sensor. The ignition system sets the required ignition timing based...