Car steering Mercedes E-Class (W123)

Steering design and specifications
Steering with a mechanism of the "screw-nut" type on recirculating balls (ball nut). The steering column is trauma-safe (energy absorbing) consists of two parts. Some...

Removal and installation the steering wheel
From here on we are talking about cars that are not equipped with air bags. Note: On vehicles produced since September 1979, a conical bolt is installed instead of a...

Removal, disassembly and installation of the steering column
Removing the steering wheel Use a socket wrench to loosen the lower steering column mounting bolt While supporting, pull out the steering column 1. Remove both lower...

Removal and installation the coupling and the steering column deformable shaft
Steering wheel coupling Deformable trauma-safe steering column tube 1. Remove both lower instrument panel covers. 2. In the engine compartment, use a socket wrench to...

Removal and installation the steering column lock
To replace a faulty lock, you need to remove the entire steering column and drill out the locking pin. Sectional view of steering mechanism 1 - bipod shaft; 2 - oil...

Removal, disassembly and installation of the steering gear without power steering
1. Set the wheels to move straight ahead. Lock the steering wheel. 2. In the engine compartment, unscrew the coupling bolts and slide it off the steering gear. 3. Apply...

Removal, disassembly and installation of the pendulum arm
1. Apply the parking brake and support the front of the vehicle on jack stands (stands). 2. Remove the cotter pin and unscrew the nuts securing the longitudinal steering...

Removal and installation of transverse and longitudinal steering rods
1. Apply the parking brake and support the front of the vehicle on jack stands (stands). Remove the wheels. 2. Remove the cotter pins and unscrew the nuts. 3. Use a...

Checking and replacing the tie rod joints
Ball joint 1. Apply the parking brake and support the front of the vehicle on jack stands (stands). 2. Rock the front wheel in both directions with your hands. If you...

Removal and installation the power steering mechanism
All operations performed correspond to those described in the subsections Removal and installation the steering wheel , Removal and installation the coupling and the...

Bleeding the hydraulic steering system
1. Check the tightness of all connections. 2. Fill the pump reservoir with hydraulic fluid up to the required level mark. 3. Start the engine and turn the steering wheel...

Removal and installation the power steering pump
1. Pump out the liquid from the pump tank (using a syringe). 2. Loosen the upper pivot bolt and the nut on the front end of the adjusting bolt. 3. Turn the adjusting...

Checking and adjusting the front wheel alignment angles
Correct front wheel alignment has a major impact on handling and reduces tire wear. Before checking them, make sure the vehicle is loaded only with its own weight, fuel,...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More similar sections for repairing other models

☛ Chassis: Steering car Mercedes W168 (1997-2004)
☛ Chassis: Steering car Mercedes W202 (1993-2000)
☛ Chassis: Steering car Mercedes W463 (1999-2019)
☛ Chassis: Steering car Mercedes W163 (1997-2005)
☛ Chassis: Steering car Mercedes W116 (1972-1980, petrol)
☛ Chassis: Steering car Mercedes Vario 814D (1996-2003, diesel)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

W210 (1996-2002)

W124 (1984-1995)