Doors, locks and windows of the car Mercedes E-Class (W123)

Removal and installation the tailgate (station wagon models)
1. Remove the luggage compartment light without disconnecting the wiring. 2. Loosen the mounting screws and release the rear panel of the body ceiling trim from the...

Removal and installation the rear door glass (station wagon models)
1. Remove the rear window wiper arm. 2. Unscrew the lock release button, remove the rear door trim panel (six screws). 3. Remove the screw from the inner handle trim and...

Removal and installation gas-filled tailgate struts (station wagon models)
1. Open the tailgate and remove the luggage compartment light without disconnecting the wiring. 2. Unscrew the mounting screws and release the rear panel of the ceiling...

Removal and installation the interior door trim panel
Models with sedan and station wagon body 1. Unscrew the door lock release button from the top panel and raise the door glass completely. 2. Release the plastic insert of...

Removal and installation a mechanical door window lifter
Removing the window handle insert View of the front door window lift levers Position of window lifter arm retaining rings behind guide grooves 1. Remove the interior...

Removal and installation an electric window lifter
Electric window lifter stop mounting bolt 1. Remove the interior door trim panel and polyethylene apron. 2. Lower the window and disconnect the wire from the negative...

Removal and installation the front door drop glass
Removal Removing the front door drop glass 1. Remove the window regulator (see Removal and installation a mechanical door window lifter and Removal and installation an...

Removal and installation the rear door drop glass
1. Remove the window regulator. 2. Loosen the mounting bolts and remove the rear guides. 3. Remove the inner and outer seals from the top of the door, after removing the...

Removal and installation fixed rear door glass
1. Remove the window regulator. 2. Unscrew the bolt and nut and remove the locking guide. 3. Remove the fixed glass and rubber seal from the door by pushing them...

Removal and installation the door
Removal 1. Open the door all the way and support it from below with a jack or stand, placing some soft material underneath. 2. Disconnect the door opening limiter from...

Removal and installation the door opening limiter
1. Remove the door trim panel, peel off the polyethylene apron at the location where the limiter is attached. 2. Remove the cotter pin and knock the axle out of the door...

Removal and installation the outer front door handle
Models with sedan and station wagon body 1. Remove the rubber plug from the end of the door and remove the two Phillips head screws. 2. Push the door handle forward,...

Removal and installation the outer rear door handle
1. Remove the seal, unscrew the rear mounting screws. 2. Push the handle forward, press the handle and remove the handle assembly. 3. Before installing the handle,...

Removal and installation the front door lock
Front door lock release rods 1. Remove the door trim panel. 2. Secure the position of the inner handle and remove it by unscrewing the Phillips head screws and...

Removal and installation the rear door lock
1. Remove the interior door trim panel. 2. Disconnect the lock release rod from the lock, then remove the inner handle and rod. 3. On models equipped with power windows...

Adjusting the sunroof
Electric sunroof Adjusting the position of the rear edge of the electric sunroof 1. Remove the trim from the sunroof by loosening the sliding bracket mounting bolts and...

Removal and installation of windshield and rear window
Windshield Windshield installation 1. Remove the interior trim moldings, leaving the top molding in place. 2. Use a blunt screwdriver to release the internal rubber...

Removal and installation rear side window glass
Removing the rear side window glass Coupe models 1. Remove the rear seat. 2. Remove the trim (three screws), window handle or power window switch, trim and rear panel....

Removal and installation the rear side window regulator
1. Remove the rear interior trim panel. Mechanical window lifter 1. Remove the cover (four screws), remove the retaining ring and disconnect the intermediate lever and...

Central locking system
The central locking system operates on engine vacuum and automatically locks all doors, the boot lid and the fuel filler flap when the left front door is locked. The...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More similar sections for repairing other models

☛ Body: Doors and windows car Mercedes W168 (1997-2004)
☛ Body: Doors and windows car Mercedes W202 (1993-2000)
☛ Body: Doors, locks and windows car Mercedes W463 (1999-2019)
☛ Body: Doors and locks car Mercedes W163 (1997-2005)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

W210 (1996-2002)

W124 (1984-1995)