Car doors and windows Mercedes A-Class (W168)

Front door — removal and installation
Removal 1. Disconnect the corrugated cover of the wiring harness from the front pillar 2 (see illustration). 2. Disconnect the multi-pin plug located under the cover by...

Door trim — removal and installation
Removal 1. Lower the door glass. 2. Remove the cover from the rear view mirror 1 (see illustration). 3. Cars manufactured before 2/01. Remove the lower and upper trims 2...

Rear side door — window lift handle removal and installation
Removal 21. Remove the retaining ring 1 from the window lift shaft using a special tool or by prying it off with a screwdriver 2. Always install the removal tool on the...

Front door window lifter — removal and installation
Removal 1. Remove the door glass, see the relevant chapter . 2. Disconnect the power window motor multi-pin connector. 3. Disconnect the wiring harness holder from the...

Window lifter motor — removal and installation
Removal 1. Lower the glass and remove the door trim, see the relevant chapter . 2. Disconnect multi-pin plug 1 from window lift motor 2 (see illustration). 3. Unscrew...

Door glass — removal and installation
Removal Attention! After installing the glass, there is no need to adjust the window lifter. 1. Remove the outside rearview mirror, see the relevant chapter . 2. Lower...

External door handle — removal and installation
Removal 1. Remove plug 1 on the inside of the door and unscrew bolt 2 with a socket head key located underneath it (see illustration). Attention! The bolt is protected...

Door lock — removal and installation
Removal 1. Lower the door glass and remove the door trim, see the relevant chapter . 2. Remove the inner door seal near the rear mounting hole on the door. 3. Remove the...

Rear Tailgate — Removal and Installation
Removal 1. Disconnect the ground (-) wire terminal from the negative battery terminal, after turning off the ignition. Warning! When you disconnect the battery from the...

Rear Tailgate — Fitting
14. Check the gaps between the tailgate and adjacent body parts. Nominal clearance values: The gap between the rear hatch and the roof is 7.0±0.5 mm The gap between the...

Rear Door Trim — Removal and Installation
Removal 1. Remove the three release pins 2 on the cover 1 of the lock (see arrows in the illustration), prying off their rivets 3 with a plastic wedge, screwdriver or...

Rear Door Lock and Switch — Removal and Installation
Cars with identification number 168.**475093 inclusive. Removal 1. Remove the rear hatch trim, see the relevant chapter . 2. Unscrew the bolts 2 securing the lock 1 and...

Gas-filled strut — removal and installation
Removal 1. Open the tailgate and secure it to prevent it from falling. 2. Pry up the locking bracket 1 of the stop with a small screwdriver 2 and remove the gas-filled...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More similar sections for repairing other models

☛ Body: Doors, locks and windows car Mercedes 190 (W201) (1982-1993)
☛ Body: Doors, locks and windows car Mercedes W124 (1984-1995)
☛ Body: Doors, locks and windows car Mercedes W463 (1999-2019)
☛ Body: Doors and locks car Mercedes W163 (1997-2005)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code