Interior cars Mercedes A-Class (W168, 1997-2001)

Repair of interior elements of W168 cars produced from October 1997 to February 2001.

Driver's side wind deflector trim — removal and installation
Removal 1. Move the steering wheel all the way down. 2. Unscrew the two screws 2 securing the trim 1 at the bottom, left and right of the steering column (see...

Passenger Side Deflector Trim — Removal and Installation
Removal 6. Remove gear 1 for adjusting the direction of air flow from the deflector, prying it off with a plastic wedge (see illustration). 7. Unscrew screw 1 and remove...

Glove box — removal and installation
Removal 1. Remove the deflector cover, see the relevant chapter . 2. Unscrew screws 1 and 2 (see illustration). 3. Remove the glove box enough to allow the glove box...

Glove box lid — removal and installation
Removal 6. Remove the glove box, see the relevant chapter . 7. Remove the metal latch on the left side of the cover. 8. Unscrew the socket head screw on the same side...

Glove box lid — fit
12. Loosen screw 1 (see illustration). 13. Fit the cover by moving it in the holes 2 and observing the required width of the gaps and the contour of the cover relative...

Driver's Side Dashboard Lower Cover — Removal and Installation
Removal 1. Remove the deflector cover, see the relevant chapter . 2. Remove the sealing trim 1 from the footwell trim 2 (see illustration). 3. Use a small screwdriver to...

Lower Instrument Panel Cover Passenger Side — Removal and Installation
Removal 12. Remove the glove box, see the relevant chapter . 13. Remove the sealing trim from the footwell trim. 14. Use a small screwdriver to pry up the plug on the...

Center console cover — removal and installation
Removal 1. Remove the deflector trim on the driver and passenger sides, see the relevant chapter . 2. Remove the radio receiver, see the relevant chapter . 3. Unscrew...

Front Center Console — Removal and Installation
1. Remove the rear part of the center console, see the relevant chapter . 2. Remove the center console cover, see the relevant chapter . 3. Remove the lower cover 1 of...

Rear of the center console — removal and installation
Removal Caution! When working on the center console with the battery connected and without switching off the ignition, the safety airbag may be triggered. For this...

Gear Shift Boot — Removal and Installation
Removal 1. Lift up the cover 1 by hand or pry it up with a plastic wedge and remove it, releasing it from the fasteners 2 on the center console (see illustration). 2....

Ashtray on the center console — removal and installation
Removal 1. Remove the gear shift lever cover, see the relevant chapter . 2. Disconnect the multi-pin cigarette lighter plug. 3. Press the 2 stop tabs 1 on the ashtray...

Front pillar trim — removal and installation
Removal 1. Fold handle 1 down, lift covers 2 up, unscrew screws 3 located underneath them and detach the handle above the door (see illustration). 2. Remove seal 4 on...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More similar sections for repairing other models

☛ Body: Interior (internal elements) car Mercedes W203 (2000-2007)
☛ Body: Interior (internal elements) car Mercedes W210 (1996-2002)
☛ Body: Interior (internal elements) car Mercedes W463 (1999-2019)
☛ Body: Interior (internal elements) car Mercedes W163 (1997-2005)
☛ Body: Interior (internal elements) car Mercedes W140 (1991-1998)
☛ Body: Interior (internal elements) car Mercedes Vito 1 (1996-2003)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code