Repair of interior elements of W168 cars of all years of manufacture.
Interior trim Recommendations for performing work in the salon When working with interior trim elements, the following recommendations must be followed. a) Use a plastic wedge, such...
Interior rear view mirror — removal and installation The interior rear-view mirror may have a rain sensor and/or automatic switching to prevent blinding from headlights of moving vehicles behind. Removal The support plate...
Front seat — removal and installation Removal 1. Move the seat all the way back and remove headrest 1 by pressing the locking button 2 (see illustration). The headrest is removed upwards from the guides 3....
Additional brake light cover — removal and installation Removal 1. Using a plastic wedge, carefully press the locking tabs 1 on both sides of the cover and lift the cover 3 (see illustration). This will release the locking...
Rear Ceiling Crossmember Trim — Removal and Installation Removal 1. Remove the seal from the crossmember trim. 2. Press the trim back by prying it up with a plastic wedge. Try to install the wedge as close as possible to the...
Central lock The central locking system locks all doors, including the tailgate, as well as the fuel filler flap, using the key in the lock of one door or using the remote control....
Central lock microswitch — removal and installation Cars without remote control. Removal Attention! To replace the central door lock contact switch, you need a complete repair kit consisting of a switch, bushings and a...
Central lock actuator — replacement The actuator of the central lock on the front door is built into the lock. If it is defective, for example, if it is not tight, the door lock should be replaced as a set...
Central lock pump — replacement The electric pump for the central locking is located in the boot. Removal 1. Fold the rear seat forward. 2. Remove the cover that covers the spare wheel. 3. Remove, if...