Contents: Removal ↡ Installation ↡
Removal
1. Remove the door glass, see the relevant chapter.
2. Disconnect the power window motor multi-pin connector.
3. Disconnect the wiring harness holder from the window regulator.
4. Drill out the blind rivets (see arrows in the illustration) with a 7 mm drill so that the rivet head falls out. Be careful not to drill through the door itself. Knock out the rest of the rivet with a punch.
Attention! Be sure to remove any remaining rivets and metal shavings from the door cavity. Otherwise, rust may appear. If the paint layer is damaged, restore it.
5. Remove the window lifter 1 from the door cavity together with the electric motor through the lower opening.
Installation
6. Insert the window regulator through the lower hole in the door and secure it to the mounting location.
7. Insert new window regulator mounting rivets and flatten them with appropriate pliers. The window regulator support plate should fit snugly against the inner door bulkhead.
8. Check the ease of movement of the window lift. If necessary, apply a thin layer of lubricant, e.g, "Isoflex Topas L32".
9. Connect the power plug to the window lift motor.
10 Secure the wiring harness holder to the window regulator. Replace the damaged holder with a new one.
11. Replace the door glass.