Cardan and rear axle of the car Mercedes E-Class (W123)

Design and technical characteristics of the cardan shaft and axle
The cardan transmission consists of two tubular shafts with an intermediate support fixed to the body base, mounted on a ball bearing. At the front and rear ends of each...

Removal and installation the cardan transmission
Cross section of the central bearing of the drive shaft 1 - front shaft section; 2 - rear section of the shaft; 3 - clamping nut; 4 - rubber bushing; 5 - locking ring; 6...

Replacing the intermediate support of the drive shaft
1. Remove the cardan shaft. 2. Mark the relative positions of the front and rear propeller shafts. 3. Remove the front propeller shaft (the nut is already loosened). 4....

Replacing the elastic coupling and centering bushings
Defective elastic couplings or centering bushings can cause increased noise, loss of lubrication and vehicle failure. Cross-section of the flexible coupling of the drive...

Rear axle and shaft design
Rear axle maintenance consists of checking the oil level in the crankcase every 16,000 km, which should be at the level of the lower edge of the filler hole. Significant...

Removal and installation the rear wheel drive shaft
1. Secure the vehicle and lift the rear part, remove the rear wheels. 2. Drain the oil from the rear axle through the drain plug. 3. Remove the brake caliper without...

Replacing the rear wheel drive shaft protective cover
If the drive protective cover is damaged, it must be replaced. The work requires a special tool. If a leak in the protective cover is detected at the point where the...

Removal and installation the rear axle
Sectional view of the anti-lock brake system sensor found on some models 34 - sensor; 35 - screw; 36 - sealing ring; 43 - rotor; 44 - main gear drive pinion; 45 - rear...

Replacing the rear axle pinion seal
Installing the wheel drive shaft seal in the rear axle housing without bearing caps 11 - tapered roller bearing; 12 - differential box; 26 - spring retaining ring; 29 -...

Replacing the rear wheel drive shaft seal
Installing the drive shaft seal into the bearing cap of early models Installing the drive shaft seal into the bearing cap of later models 1. Remove the desired wheel...

Replacing the rear axle suspension bracket
1. Place the car on stops (wedges), lift the rear of the car and secure it. 2. Place a jack trolley under the rear axle housing. 3. Unscrew the bolts securing the rear...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More similar sections for repairing other models

☛ Transmission: Cardan shaft and axle shafts car Mercedes 190 (W201) (1982-1993)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

W210 (1996-2002)

W124 (1984-1995)