Battery Care Rules If you are going to keep the battery working for as long as possible, please observe the following rules: when the engine is not running, turn off all electrical...
Battery check Checking the density of the electrolyte in the battery must be done every 3 months in order to determine the load capacity of the battery. The check is made by a density...
Accumulator charging The battery must be charged when the battery is removed from the vehicle. Charge the battery with a charging current equal to 0.1 of the battery capacity and until the...
Battery — removal and installation Removing The location of the screws that secure the battery terminals Battery bolt location 1. Loosen the fastener and remove the negative battery terminal. 2. Remove...
Charging system If the battery charging control lamp does not light when the ignition is turned on, check the wiring connection to the generator and the integrity of the control lamp....
Generator — removal and installation On all models, the alternator is mounted on the right front side of the engine and is driven by an auxiliary drive belt. On models with 4-cylinder and 6-cylinder SOHC...
Replacing the voltage regulator unit and brush holder The location of the screws for fastening the voltage regulator unit and brush holder Removing the voltage regulator unit and brush holder 1. Remove the generator. 2....
Engine start system If the starter does not work in the key position "engine starting", the following reasons are possible: Battery defective. Open circuit between the ignition switch,...
Starter — removal and installation On all models, the starter is bolted to the clutch housing on the left rear of the engine. Access to the starter is possible from under the car. On diesel models with an...