Fuel system with carburetor Mercedes E-Class (W124)

Technical characteristics of the fuel system
Fuel pump Type Mechanical, driven by an eccentric intermediate shaft via a pusher Pressure created by the fuel pump at idle speed 0.20 – 0.40 bar Fuel pump performance...

General information about carburetors
The fuel supply system consists of a STROMBERG or PIERBURG carburetor, a fuel tank, a mechanical fuel pump, fuel lines, an air filter and a cartridge-type fuel filter...

Air filter and filter element — removal and installation
Removal Loosening the clamp securing the air supply pipe to the carburetor Loosening the clamp securing the air supply pipe to the air filter housing Removal the air...

Engine air inlet temperature control unit
Examination Engine air inlet temperature control unit (in the cold engine start position) 1 – thermostat; 2 – thrust; 3 – spring; 4 – additional spring; 5 – damper; 6 –...

Fuel pump — removal and installation
Removal Removal the fuel pump from the engine Removal the fuel pump drive pusher Removal the fuel pump sealing block 1. Remove the ground cable from the battery. 2....

Accelerator cable — removal and installation
Removal Accelerator Cable Square Fastener Location Location of the plastic fastening brackets for the accelerator cable sheath 1. In the engine compartment, disconnect...

Carburetor STROMBERG 175 CDT
1 – carburetor body; 2 – float chamber; 3 – float; 4 – needle valve; 5 – needle valve; 6 – carburetor cover; 7 – piston; 8 – diaphragm; 9 – needle; 10 – electromagnetic...

Replacement of carburetor elements STROMBERG 175 CDT
Removal the carburetor shock absorber cover together with the piston vibration damper Removal the shock absorber from the carburetor body The location of the screw that...

Carburetor PIERBURG 2E-E
Before diagnosing the carburetor, check the ignition timing, the serviceability of the spark plugs and the interelectrode gap in the spark plugs. Check that the...

Replacement of carburetor elements PIERBURG 2E-E
Damper actuator Carburetor flap actuator PIERBURG A – carburetor body; B – thrust; C – actuator housing; D – fastening ring; E – screw 1. Remove the air filter. 2....

Removal and installation the carburetor
Removal 1. Remove the carburetor on a cold engine. Remove the ground wire from the battery. 2. Remove the air filter. 3. Using clamps, pinch the fuel feed and return...

Intake manifold — removal and installation
Removal 1. Remove the ground cable from the battery. 2. Drain the coolant from the cooling system. 3. Remove the carburetor. 4. Remove the brake booster vacuum hose from...

Intake Manifold Heater — Removal and Installation
Removal 1. Remove the ground cable from the battery. 2. Disconnect the electrical connector from the intake manifold heater. 3. If present, unscrew and remove the intake...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More similar sections for repairing other models

☛ Power unit: Fuel system car Mercedes W168 (1997-2004)
☛ Power unit: Fuel system car Mercedes W202 (1993-2000)
☛ Power unit: Power system (gasoline) car Mercedes W463 (1999-2019)
☛ Power unit: Power system (gasoline) car Mercedes W163 (1997-2005)
☛ Power unit: Power system (carburetor) car Mercedes W116 (1972-1980, petrol)
☛ Power unit: Power and exhaust system car Mercedes Sprinter (1995-2000, diesel)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

W210 (1996-2002)

W124 (1984-1995)