Cardan shaft and axle shafts of the car Mercedes 190 (W201)

Technical data
Main gear Type - Unsprung, body-mounted, mounted on the rear suspension cross beam Half shafts Type - Steel shafts with constant velocity joints on each side Cardan...

Basic information
The cardan transmission transmits torque from the gearbox to the rear axle. The two-piece cardan transmission is connected at the front to the central bearing by a...

Main gear — draining and filling with oil
1. This operation is carried out more quickly and efficiently immediately after a trip during which the final drive warms up to normal operating temperature. 2. Place...

Main gear — removal and installation
Note: Installation will require new rear driveshaft coupling nuts, axle joint bolts and final drive support bolt nuts. Removal 1. Place chocks under the front wheels....

Main gear oil seals — replacement
Replacing the main gear oil seals is a complex task that requires partial disassembly of the main gear. Therefore, this work should be carried out at a Mercedes-Benz...

Half shafts — removal and installation
Note: A new axle nut and bolts will be required for installation. Removal 1. Remove the wheel trim/hub cap (depending on what is installed), and using a hammer and a...

Protective half shaft covers — replacement
1. Remove the axle shafts as described in paragraph 5 . 2. Clean the axle shaft and secure it in a vice. 3. Use a lever to pry the sealing cap off the end of the inner...

Cardan transmission — removal and installation
Note: New front and rear driveshaft coupling nuts will be required for installation. Removal 1. Place chocks under the front wheels. Jack up the rear of the vehicle and...

Rubber couplings of the cardan transmission — inspection and replacement
Examination 1. Apply the parking brake, then raise the front of the vehicle and support it on stands (see " Lifting the car and placing it on supports "). 2. Carefully...

Cardan shaft support bearing — inspection and replacement
Examination 1. Wear in the support bearing will cause noise and vibration when the car is moving. It is best to check the bearing with the driveshaft removed ( see...

Universal joint of the cardan transmission — inspection and replacement
Examination 1. Wear in the universal joint is characterized by vibration in the drivetrain, noise during acceleration, and metallic creaking and annoying sounds as the...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More similar sections for repairing other models

☛ Transmission: Cardan and rear axle car Mercedes W123 (1976-1985)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

190 (W201) (1982-1993)