Brake system of the car Mercedes C-Class (W203)

Design and description of the brake system
Hydraulic elements of the brake and auxiliary systems BAS and ESP 1 - Dual-circuit GTZ; 5a - Right front wheel brake caliper; 5b - Left front wheel brake support; 6a -...

Brake system specifications
General parameters Design Hydraulic, dual-circuit with vacuum booster. Electronic anti-skid system (stability stabilization - ESP), Brake Assist (BAS) and Anti-lock...

Replacing the front disc brake pads
Use brake pads recommended by the manufacturer. Refer to Section Purchase of spare parts Introduction. Attention! If the brake pads are to be used again, they must be...

Removal and installation the front caliper
Removal 1. Mark the position of the front wheels relative to the hubs with paint. This will allow you to install the balanced wheels in their original position during...

Replacing rear brake pads
Brake pads are subject to control by technical supervision authorities. In addition, they are intended for use in a specific car model. Use brake pads recommended by the...

Removal and installation the rear caliper
Removal 1. Mark the position of the rear wheels relative to the hubs with paint. This will allow you to install the balanced wheels in their original position during...

Removal and installation the brake disc
To achieve uniform braking on both sides, the brake discs must have identical friction surfaces in terms of their appearance and roughness. Therefore, it is necessary to...

Checking the brake disc
1. Mark the position of the wheels relative to the hubs with paint. This will allow you to install the balanced wheels in their original position during assembly. Loosen...

Dual master cylinder
Dual master cylinder 1 - Tank seat seal; 2 - Cuff; 3 - Piston (to the pusher); 4 - Lock washer; 5 - Retaining ring; 6 - Vacuum seal; 7 - Intermediate ring; 8 - Clip; 9 -...

Replacing the parking brake pads
The parking brake is built into the brake drum. Removal 1. Release the parking brake completely and loosen the drive cable, refer to Section Checking the brake system....

Removal and installation the parking brake cable
Removal 1. Depending on the model, fold the rear seat forward or remove it, refer to the relevant section. 2. Remove the floor mat under the rear seat. Note: The mat...

Removal and installation the brake light switch
1 - Brake light switch 2 — Brake pedal The brake light switch is located on the brake pedal support. Check the operation of the brake light switch. Removal 1. Turn off...

Bleeding the brake system
Rules for handling brake fluid Brake fluid is poisonous. Never suck it up by mouth or through a hose. Store brake fluid only in bottles that cannot be accidentally...

Removal and installation the brake hose
Caution! Follow the rules for handling brake fluid described in Section Bleeding the brake system . The brake system pipes connect the main brake cylinder with the four...

Checking the brake booster
1 - Vacuum hose 2 - Brake pipe 3 — Master brake cylinder 4 — Brake fluid reservoir The driver's foot pressure on the brake pedal is amplified by the brake booster, using...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More similar sections for repairing other models

☛ Chassis: Brake system car Mercedes W168 (1997-2004)
☛ Chassis: Brake system car Mercedes W124 (1984-1995)
☛ Chassis: Brake system car Mercedes W463 (1999-2019)
☛ Chassis: Brake system car Mercedes W163 (1997-2005)
☛ Chassis: Brake system car Mercedes W140 (1991-1998)
☛ Chassis: Brake system car Mercedes Vito 1 (1996-2003)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

190 (W201) (1982-1993)