Suspension front and rear car Mercedes C-Class (W203)

General description of suspension and steering
Chassis of the car The car is equipped with a front suspension in the form of triangular transverse levers and a rear suspension in the form of a spatial lever system,...

Suspension and steering specifications
Individual characteristics are also given in the text of the Chapter and, if their implementation is mandatory, are highlighted in bold. General parameters Wheelbase, mm...

Design and description of front wheel suspension
Front wheel suspension 1 - Upper support; 2 - Coil spring; 3 - Connecting rod; 4 - Shock absorber; 5 - Cross connection (rear wishbone); 6 - Anti-roll bar; 7 -...

Removal and installation the front shock absorber strut
Removal 1. Mark the position of the front wheel relative to the hub with paint. This will allow you to install the balanced wheel in its original position during...

Repair of front wheel suspension strut
Front wheel suspension shock absorber 1 - Nut M14 x 1.5, 60Nm; 2 - Washer; 3 - Stop; 4 - Nut, 20Nm, self-locking, must be replaced; 5 - Rubber gasket; 6 - Shock absorber...

Adjusting the clearance in the front wheel bearings
1. Mark the position of the front wheel relative to the hub with paint. This will make it easy to reinstall the balanced wheel. Loosen the wheel mounting bolts with the...

Design and description of rear wheel suspension
Rear wheel suspension 1 - Rear wheel drive; 2 - Main gear; 3 - Coil spring; 4 - Shock absorber; 5 - Rear suspension beam; 6 - Torsion bar anti-roll bar; 7 - Rear...

Removal and installation the rear shock absorber
Shock absorber and rear suspension spring 1 - Lock nut, 30 Nm; 2 - Nut; 3 - Washer; 4 - Rubber buffer; 5 - Rubber buffer; 6 - Shock absorber; 7 - Bolt; 8 - Nut M10,...

Removal and installation the rear spring
Attention! Depending on the vehicle equipment, rubber supports of different heights are installed. When replacing, it is necessary to measure the height of all supports....

Car Wheel Alignment Angles — General Information
Wheel alignment angles have a significant impact on vehicle stability, tire wear and fuel consumption. The angle values are given in Specifications . Camber is the tilt...

Conditions for checking wheel alignment angles
Checking the vehicle's installation angles requires an inspection pit or a special measuring lift. When taking measurements, the following conditions must be met: The...

Front wheel alignment
Front Wheel Alignment Ruler Beissbarth — № P860 000 883, № P 872 Matra — № 002 548 199 074 Bosch — № 2 688 190 000, № 1 688 190 022 Adjustment of the camber and...

Rear wheel adjustment
Rear wheel alignment adjustment Adjustment of rear wheel alignment is performed using an eccentric The rear wheel alignment is given in Specifications . The toe-in of...

Checking the vehicle body clearance
Measuring suspension clearance. (Corresponds to the angle of inclination of the drive shaft to the horizontal). 1. The level of the front axle of the vehicle is checked...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More similar sections for repairing other models

☛ Chassis: Suspension car Mercedes W168 (1997-2004)
☛ Chassis: Car suspension car Mercedes W124 (1984-1995)
☛ Chassis: Car suspension car Mercedes Sprinter (1995-2000, diesel)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

190 (W201) (1982-1993)