Contents: Removal ↡ Installation ↡
The rear door handle is similar in design to the front door handle, the differences are indicated below.
Removal
1. Remove the door seal at the height of the door lock from the door groove.
2. Loosen the Allen bolt (arrow) 5 turns with a 3 mm socket wrench through the hole in the door. The Allen bolt is accessible through the hole (10) on the front side of the door.
[Article obtained from this portal: MercedesMan]
3. Pull the rear door guide back first and then out.
4. Pull the door handle with the gasket back out of the support bracket. The support bracket can be removed from the inside of the door if necessary. To do this, however, you will need to remove the door trim.
5. Remove the rubber door handle gaskets.
Installation
1. Insert the door handle with the gasket and at the same time insert it into the door lock control lever.
2. Install the rear guide.
3. Secure the door lock with an Allen bolt.
4. Install the door seal and check the door operation.