Car steering Mercedes S-Class (W126)

General description of steering
The steering system consists of a steering wheel, a steering shaft, a steering gear, and a steering damper. The steering wheel is attached to the steering shaft, which...

Removal and installation the steering wheel
Removal Use a small screwdriver to pry the brand emblem (18) off the decorative steering wheel trim (25). Note: There is no need to remove the decorative steering wheel...

Removal and installation tie rod ends
Removal Loosen the wheel bolts. Raise and support the front end. Remove the front wheel. Remove the lock nut (35) from the end of the connecting rod (10), holding the...

Dust boot of the articulated joint of the connecting rod and steering rod
Removal and installation Note: To facilitate the installation of two rings, two mounting caps can be made. 1. Cap for installing wire retaining ring. 2. Cap for...

Power steering servo — removal and installation
All models are equipped with power steering, which is very convenient. The energy-absorbing element between the steering wheel and the steering column is made of...

Removal and installation the power steering pump
Loosen the wing nut of the reservoir, remove the cover, spring and damper plate. Suck out the oil from the reservoir. Remove the high pressure hose from the pump, plug...

Power Steering Fluid Replacement
Use a syringe to suck out the oil from the power steering pump reservoir. Remove the top damper plate and check the filter for cleanliness and damage. Pour new fluid...

Removal and installation the articulated joints of the connecting rod
Note: Depending on the type of the hinge joint, it is secured to the connecting rod with one or two clamps or one tightening cone ring and a lock nut. The hinges are...

Tie rod/steering rod joint boots — check
Jack up and support the front of the car. Using a lamp, check the anthers for damage and the presence of traces of grease on the casings and near them. A damaged boot...

Steering gear play — check
Set the steering wheel to the center position. Turn the steering wheel from side to side through the open window, while simultaneously monitoring the movement of the...

Checking the oil level
In the steering gear housing Remove the screw located in the middle of the steering gear housing (40). The oil should reach the lower edge of the screw hole. If...

Steering system clamp bolts — tightening
The steering system clamp bolts should be tightened to the specified torques every 20,000 km. Jack up the car and support it. The tightening torque of the bolts securing...

Power steering hydraulic pump drive belt
Remove the fan belts from the crankshaft pulley, located in front of the hydraulic pump drive belt. Loosen the clamp bolts (1, 2 and 3). Turn the tensioner (4) so that...

Wheel alignment angles
Optimal driving conditions and minimal tire wear can only be achieved with correct wheel alignment angles. In case of uneven tire wear or if the car does not "hold" the...

Steering Specifications
Steering Specifications

Tightening torques for threaded connections
Steering control (general part) Engine 280S and 280SE 380SE and 500SE 350SE and 450SE Bolts for mounting the control on the frame (body) bracket 100-110 100-110 100-110...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More similar sections for repairing other models

☛ Chassis: Steering car Mercedes W168 (1997-2004)
☛ Chassis: Steering car Mercedes 190 (W201) (1982-1993)
☛ Chassis: Steering car Mercedes W210 (1996-2002)
☛ Chassis: Steering car Mercedes W463 (1999-2019)
☛ Chassis: Steering car Mercedes W163 (1997-2005)
☛ Chassis: Steering car Mercedes Vito 2 (2003-2014, diesel)

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code

W140 (1991-1998)