Inductive sensor of the speed of the driven shaft of the automatic transmission (cars with engines 111, 601 and 611.980)
Removal
1. Remove the electrohydraulic unit. The B91.1 wiring connector cannot be disconnected until the B91 sensor has been removed (see figure 6.65).
Figure 6.65. Inductive sensor of automatic transmission driven shaft speed (cars with engines 111, 601 and 611.980):
1. Bolt,
2. Fixator,
3. Washer,
B91. Inductive sensor of automatic transmission driven shaft speed,
B91.1. Wiring connector.
2. Disconnect the wiring connector B91.1 from the retainer 2.
3. Unscrew bolt 1.
4. Remove the B91 sensor and disconnect the B91 wiring connector. Lift the pin (arrow) with a screwdriver until the B91.1 connector is completely disconnected.
Installation
5. Installation is carried out in the reverse order of removal.
Inductive sensor of the speed of the driven shaft of the automatic transmission (cars with engine 104.900)
Removal
1. Turn off the ignition.
2. Disconnect adapter 4 (see figure 6.66).
Figure 6.66. Inductive sensor of automatic transmission driven shaft speed (cars with engine 104.900):
1. Bolt,
2. Inductive sensor of the speed of the driven shaft of the automatic transmission,
3. Sealing ring,
4. Adapter.
3. Unscrew bolt 1 securing sensor 3 and remove it.
Installation
4. Installation is carried out in the reverse order of removal. Replace sealing ring 3.
Original can be found on the website Mercedesman.ru