Right axle shaft flange seal (vehicles with engine 104.900) (Mercedes-Benz Vito W638)

Removal

1. Wipe the surface around the seal.

2. Remove the seal 1 (see figure 6.69).

Figure 6.69. Right axle shaft flange seal (on cars with engine 104.900):
1. Seal,
2. Punch,
3. Differential housing.

Installation

3. Installation is carried out in the reverse order of removal. Install oil seal 1 and press it in using punch 2. Fill the gap between the lips of the oil seal with plastic grease. Make sure the seal is installed correctly.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article has been verified: Lukyanov Nikita Ilyich

Share with friends:

◀ Previous

Mercedes Vito 1 / Automatic gearbox

Next ▶

Left axle shaft flange seal
Radial seal of the GTR
Inductive sensor of the speed of the driven shaft of the automatic transmission
Inductive sensor of rotation speed of the turbine of the GTR
Automatic transmission mode software switch (cars with engines 111.601 and 611.980)

Rear cover of automatic transmission (on cars with engine 104.900)
Gear selector lever position sensor (vehicles with engines 111, 601.970 and 611.980)
Automatic transmission oil cooler (cars with engine 104.900)
Automatic transmission oil cooler fan (cars with engine 104.900)
Gear shift cable

More similar articles for repairing other models

☛ Checking the engine oil level using a dipstick Mercedes W168 (1997-2004)
☛ Engine hood — opening and closing Mercedes W202 (1993-2000)
☛ Design and technical characteristics of the cardan shaft and axle Mercedes W123 (1976-1985)
☛ Disassembly and assembly of the axle shaft Mercedes W463 (1999-2019)
☛ Replacing the rear propeller shaft output flange seal Mercedes W163 (1997-2005)
☛ Removal and installation the drive shaft flange and radial thrust… Mercedes W140 (1991-1998)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Vito 1 (1996-2003)