Contents: Removal ↡ Installation ↡
Removal
1. Set the gear selector lever to position "P".
2. Remove the left wheel.
3. Disconnect the wiring connector from the multi-function switch.
4. Disconnect the multifunction switch wiring retainer.
5. Unscrew bolts 2 and 3 securing cover 1 and remove it.
Installation
6. Installation is carried out in the reverse order of removal. Replace gasket 4. Unscrew bolts with pins 3 from below.
Figure 6.69. Automatic transmission rear cover (cars with engine 104.900):
1. Back cover,
2. Bolt,
3. Bolt with pin,
4. Gasket.