Automatic transmission mode software switch (cars with engines 111.601 and 611.980) (Mercedes-Benz Vito W638)

Removal

1. Disconnect the negative cable from the battery.

2. Remove the center panel 1 from the instrument panel (see figure 6.62).

Figure 6.62, Automatic transmission mode software switch:
1. Central panel,
S4. Automatic transmission mode software switch,
S4.1. Wiring connector.

3. Disconnect the S4.1 wiring connector and unhook the S4 program switch.

Installation

4. Installation is carried out in the reverse order of removal.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article has been verified: Lukyanov Nikita Ilyich

Share with friends:

◀ Previous

Mercedes Vito 1 / Automatic gearbox

Next ▶

Gearshift Solenoid valves
Electrohydraulic control unit
Automatic transmission control unit
Automatic transmission pan
Replacing transmission fluid and oil filter of automatic transmission

Inductive sensor of rotation speed of the turbine of the GTR
Inductive sensor of the speed of the driven shaft of the automatic transmission
Radial seal of the GTR
Left axle shaft flange seal
Right axle shaft flange seal (vehicles with engine 104.900)

More similar articles for repairing other models

☛ Automatic transmission Mercedes W168 (1997-2004)
☛ Driving mode selection switch Mercedes W202 (1993-2000)
☛ Automatic transmission mode switch Mercedes W124 (1984-1995)
☛ Starting the movement and switching the automatic transmission Mercedes W463 (1999-2019)
☛ Visual inspection of automatic transmission for leaks Mercedes W163 (1997-2005)
☛ Towing cars with automatic transmission Mercedes W126 (1979-1991, petrol)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Vito 1 (1996-2003)