Contents: Removal ↡ Installation ↡
Removal
1. Remove the bottom protective cover.
2. Remove the flange 1 of the front and rear 2 parts of the exhaust system (see figure 2.6).
Figure 2.6. Exhaust pipe:
1. Front part of the exhaust system,
2. Rear part of the exhaust system,
3. Bolt,
4. Gasket,
5. Nut,
R22. Oxygen sensor.
3. Remove the back part 2.
4. Remove the oxygen sensor (lambda probe) R22.
5. Remove the front part of the exhaust system 1.
6. Check the connecting surfaces of the flanges and outlet pipes for corrosion and damage.
Installation
7. Installation is carried out in the reverse order of removal. Replace the self-locking nuts 5, check the condition of the gasket 4 and replace it if necessary.