Figure 24
1. Turn on the windshield wiper
2. One movement of the wiper blades
To turn on the windscreen wiper, turn the combination switch to the required position depending on the intensity of the rain.
Windscreen wiper operating modes
| 0 | Windscreen wiper is off |
| I | Intermittent operation mode (the interval depends on the amount of water) |
| II | Normal operating mode |
| III | Accelerated mode of operation |
Please note: When the vehicle slows down to less than 5 km/h or comes to a standstill, the windscreen wiper will automatically switch to the next lower setting. When the vehicle accelerates to a speed of more than 8 km/h, the switched-on windshield wiper automatically switches to the initial operating mode.
A single movement of the windscreen wiper blades is activated by briefly pressing the tip of the switch lever in the direction of arrow 2. In this case, the windscreen wiper performs one movement of the blades without supplying water from the windscreen washer reservoir. To turn on the windshield washer, press the tip of the switch lever in the direction of arrow 2 until the resistance point is reached.
[Original published on the website: mercedesman]
The windshield wiper cleans the glass using water supplied from the windshield washer reservoir.
The rear window wiper automatically cleans the glass when the windscreen wiper is on and the reverse gear is engaged.
Rear window wiper
The switch is located on the center console control panel.
Figure 25
1. Intermittent mode
2. Windscreen washer
The rear window wiper is switched on and off by alternately pressing the upper part (1) of the switch button with the ignition on. To turn on the rear window washer, press the lower (2) part of the switch button.
After pressing the switch, the wiper will continue to operate for approximately 5 seconds.