Contents: Windshield ↡ Rear window ↡
Windshield
Removal the windshield wiper arm
1 - Lid
2 - Nut
3 - Lever
1. To prevent the windshield wipers from operating spontaneously in response to a signal from the rain sensor, remove the key from the ignition switch.
2. Make sure the brushes are stopped in the parking position (horizontally, close to the lower edge of the windshield).
3. Once folded, remove the protective cover (1), loosen the mounting nut (2) and, using a suitable puller, remove the wiper arm (3) from the drive spindle, being careful not to break the windscreen.
4. Installation is carried out in the reverse order - make sure that the brush is in the parking position.
Rear window
1. The procedure for removing/installing the lever is similar to that described above for windshield wipers - make sure that the brush is in the correct parking position (horizontally, close to the top edge of the rear window).
1 - Lid
2 - Nut
3 - Lever